Pumps and Related Parts

Start Capacitor1-7/16"dia x 2-3/4"hgt

Note: This Wet End is no longer available but we do have an alternative which is not an exact replacement but will work as long as your connecting plumbing is not rigid and can be move a little.. Meaning your pump is plumbed with flexible pipe so the...

This part is a 10' section of Air Tubing 1/8" inside diameter is used with Air Button, Air Button Style Topsides and Air Switch Applications and between Garden Tub Pumps and Air Button Switches...   Air Tubing Inside...

This pump is a 1 1/2" which measures about 2 3/8" across the threads with Center Discharge Style 48 Frame Pump Wet End... This Motor is 115V with 2 Speeds and Is considered to be a 1HP with 11.0 A on High Speed and 2.9A on Low Speed... The Waterway...

The Waterway center discharge wet end has been discontinued and replaced with the E-Series Center Discharge wet end by the manufacturer. Please be sure which wet end you have as the parts are not interchangeable. The easiest way to identify which wet end...

This is a XP2e 1.5HP Impeller.. The Impeller has a 2 5/8" Eye width for an Aqua-Flo 48 or 56 Frame Wet End 1.5HP Motor would be about 9.0 Amps on high speed at 230V or 14.0 Amps on High at 115V. See the links below for seals, bearing and other parts...

This Wet End is a 2" x 2" 2.0HP 48 or 56 frame Ultimax Vico® that would normally be found an a 230V pump with 10.0 Amps High speed or 16.0 Amps at 115v..  This side discharge, 2" x 2" mbt which would measure about 3" edge to edge on the threads,...

This part is a Pump Union, 2" Female Buttress Thread x 1-1/2" Slip..    Half Union Fitting Complete Complete Pump Union Union Fitting Application Pump First Plumbing Connection Size 1-1/2", 2" First Plumbing Connection Type Female...

Aqua-Flo has discontinued this wetend.  This part is a Complete Verticle Mount Style FMVP 1.0HP Aqua-Flo 1 1/2" x 1 1/2" (Which measures about 2 3/8" Across the Threads) Adjustable Suction Side discharge 48 frame wet end for FMVP pumps only. This...

You are buying a 3 HP 48 or 56 Frame Universal 2" X 2" Wet End / Pump complete with Barb, Silicon, Screws, Volute, Impeller, Seal, Face and the Wear Ring. This Wet End will work for a 2HP , 3HP or 4HP Motor To determine the HP refer to the chart below...

Vico/Balboa Ultima/Ultra Flo Pump ImpellerClosed face impeller made for the Ultima and Ultra Flo spa pumps by Vico/Balboa. Rated at 3/4hp, it is used in an Ultima and/or Ultra Flo pump wet end, and must be installed on a 3/4hp (or greater) thru bolt...

This pump complete is not longer available but we have a solution.. If you need the motor click here and then click on the pump parts section.. Order the motor and then order the pump parts needed to complete the repair while reusing your pump housing....