Pumps and Related Parts

This Wet End is a 2" x 2" 1.5HP 48 or 56 frame Ultimax Vico® that would normally be found an a 230V pump with 9.0 Amps High speed or 14.0 Amps at 115v..  This side discharge, 2" x 2" mbt which would measure about 3" edge to edge on the threads,...

This Seal Kit with bearing is used ONLY in Watkins HotSpring Caldera Wet Ends where the motor has the Vendor code of 3536. This kit features the seal, (1) bearing and an install tool as well as silicone to install the seal with.. It is 1 39/64" Across...

This Seal Kit is used ONLY in Watkins Hot Spring Caldera Wet Ends where the motor has the Vendor code of 3536. This kit features the seal and an install tool as well as silicone to install the seal with.. It is 1 39/64" Across the back of the Spring...

This Seal Set is used ONLY in Watkins HotSpring Caldera Wet Ends where the motor has the Vendor code of 3536. It is 1 39/64" Across the back of the Spring Seal part that goes into the volute or wetend back and the Ceramic & Rubber part that goes...

This Kit Fits Watkins, Vendor #4081, Wavemaster Pumps found under the name Wavemaster. This Kit Features (2) Bearings, (1) Seal and (1) 1/2oz Tube of The Professor's Silly Juice a Specially Formulated for Hot Tubs Silicon Sealer.   Note: Watkins...

This kit Fits Watkins, Vendor #4081, Wavemaster XP2 Pumps found under the name Wavemaster with the Vendor Code 4081 only.. Features (1) Seal for XP2 Pumps on Hotspring Watkins Hot Tubs, Seal Install Tool and (1) 1/2oz Tube of The Professor's Silly Juice...

This circulation pump is a 230V Replacement for a Power Right pump found in some Cal Spas.. This Pump is a 2" X 2" Wet End which measures about 3" edge to edge across the threads.. This pump is a 48 frame 230V Side Discharge wet end with a 2" suction...

This Jet Pump is found from the factory in many hot tubs and will be an easy installation for people who are handy.   This pump is a 56 frame XP2e 1.5HP 230V Side Discharge wet end with a 2" suction side and 2" pressure side which measures about...

This video is about The Spa Guy showing you how to replace a freeze damaged pump pressure side pump union , slice to the flex pipe where it was freeze damaged... #dynastyspa #dynastyhottub    #sparepair #hottubrepair ...

This Kit is a 45° 2" Pump Union To Plumbing Glue Connect Kit found in many Dynasty Brand Hot Tubs. The Pump Union which measures about 3" Inside the threads glues into a 2" Slip X Slip 45° fitting on one side and then a 2" Slice Valve Glues...

This Kit is a 45° 2" Pump Union To Plumbing Connect Kit found in many Dynasty Brand Hot Tubs. The Pump Union which measures about 3" Inside the threads glues into a 2" Slip X Slip 45° fitting on one side and then a 2" Slice Valve Glues...

This O-ring is used on some 1 1/2" Pump Union that measures 2 1/8" Center to Center of the o-ring groove.. Part Type    O-RingJet Part Type    Gasket/O-RingCross Section    1/8"Union Fitting...