Pumps and Related Parts

Vico / Balboa Ultima side discharge wetend, 3/4 HP. This side discharge wetend fits 48 frame motors and has 1.5" union connections that measure 2-3/8" across the threads.

This part is a Complete Wet End, that fits 36675 ,XP2, 4081, 1.5HP, 2"x 2" , 48fr.   That parts fits only Vendor # 4081 on Watkins Wavemaster pump with the following numbers 06115734-1, 39583,...

1.0 Horsepower, 48 frame thru-bolt pump motor for hot tubs, spas and whirlpool baths. This 115 Volt motor has an amp rating of 12.0 and is a single speed model (3450 RPM). Accepts wetends by all...

Vico / Balboa 1.0 HP center discharge wetend for 48 frame motors. This wetend has 1-1/2" union connections that measure about 2-3/8" across the threads.  Note: This wet end would fit motors that have...

This Impeller and Seal Kit is used ONLY in a 6500-907 WTC-50M Jacuzzi® Premium or Sundance® Hot Tub Circulation Pump Wet End. The impeller may have the number B432-01, B432-02, B432-03, B432-04,...

This Impeller and Seal Kit is used ONLY in Intertek Impeller & Seal Kit for Circulation Pump, TheraMax II, 1/15hp, 230v, Sundance or Jacuzzi, 02410512-2 or 6500-907 Pumps Only. The impeller may have...

This Impeller and Seal Kit is used ONLY in Intertek LX 48WTC, 1/8HP, 115 or 230V, WTC0153, Side Discharge Pumps Only. The impeller may have the number B706-01, B706-02, B706-03, B706-04, B706-05 on...

This Impeller is used ONLY in Intertek WTC50 Pumps Only. The impeller may have the number B432-01, B432-02, B432-03, B432-04, B432-05 on the back. The impeller measures about 3 5/8" across but the...

Rare Vico / Balboa Ultima 2.0 HP, 230 Volt, 56 frame spa pump assembly in 2 speed. This side discharge pump has 2" unions that measure 3" across the male threads. Most Ultima pumps are 48 frame but...

This pump is a Wow High Performance Pump with 1 1/2" x 1 1/2" connections that measure about 2 3/8" across the threads.. It is a .50 HP 115V 5.5 Amp pump with an Air Switch and Cord.. It also has...

3.0 HP impeller for the Waterway EX2 pumps assemblies. This impeller is normally found on motors with a 10.7-12.0 amp motor and fits between the Face and the Volute of an EX2 Wet End. I would advise...