Parts by Group

This part is a 2" which measures about 3" ID Heater Split Nut Kit which includes the split nut , (2) Screws and a gasket for use with a 2" Heater Union that would measure about 3" Edge to Edge on the threaded side. The Heater Flange Split Nut mounts to...

This Kit features a 5HP Impeller and 1000 Seal with Silicon and a Seal Install Tool that fits an Executive 48 Frame Wet End up to 5HP Motor and a 56 Frame Wet End 5HP Motor. This Impeller fits between the Face and the Volute of an...

This Kit features a 4HP Impeller and 1000 Seal with Silicon and a Seal Install Tool that fits an Executive 48 Frame Wet End up to 5HP Motor and a 56 Frame Wet End 4HP Motor. This Impeller fits between the Face and the Volute of an...

This Kit is features a 3HP Impeller and 1000 Seal with Silicon and a Seal Install Tool that fits an Executive 48 Frame Wet End up to 3HP Motor and a 56 Frame Wet End 3HP Motor. This Impeller fits between the Face and the Volute of an...

This Kit is features a 2HP Impeller and 1000 Seal with Silicon and a Seal Install Tool that fits an Executive 48 Frame Wet End up to 3HP Motor and a 56 Frame Wet End 2HP Motor. This Impeller fits between the Face and the Volute of an...

You are purchasing a 1HP Impeller and 1000 Seal with Silicon and a Seal Install Tool that fits an Executive 48 Frame Wet End up to 2HP Motor and a 56 Frame Wet End 1HP Motor. This Impeller fits between the Face and the Volute of an...

This is a Kit that features (1) PS-1000 Seal and (2) Bearings that fit most motors that are mated to Waterway Pump Wet Ends, The Professor silly Juice to seal the seal and a Tool to push the seal into place. This Seal is used in Waterway Wet...

This is a Kit that features (1) PS-1000 Seal and (1) Bearing that fit most motors that are mated to Waterway Pump Wet Ends, The Professor silly Juice to seal the seal and a Tool to push the seal into place.  This Seal is used in Waterway Wet...

This part is a PS-1000 Seal Kit with Silicon and a Seal Install Tool. This Seal is used Primarily in Waterway Brand Wet Ends. It is 1 3/8" Across the back of the Spring Seal part that goes into the volute or wetend back and the Ceramic...

Please Read this Note before proceeding!!NOTE: This Part will NOT Fit Sundance®or Jacuzzi®Tubs with a Intertek LX Wet End for internal parts of that wet end you already have click here Jacuzzi® & Sundance® LX...

This 3.5 Horse Power Impeller & Seal Kit that fits a 56 Frame Pump Wet Ends manufactured by Intertek LX Brand only. See NOTES Below... This Kit consists of The Impeller, Seal, Silicon and Seal Installation Tool.   The pumps...

This 2 Horse Power Impeller, Seal, Silicon and Seal Installation Tool that fits 56 Frame Pump Wet Ends manufactured by Intertek LX Brand only. The pumps this impeller & Seal Kit fits usually have the part number WUA-200, WP-200 or LP-200 on the...