Parts by Group

Internal, Pentair,  Cyclone Jet, 5" face diameter, Swirl, 5 Scallop, Dark Gray This will replace Sundance Intelli-Jet LX, 1999-2002   Installation Type Twist Lock Face Diameter 5" Jet Part Type Internal Diffuser...

This parts is an Executive 2" Threaded Face plate assembly (Which will measure about 3" Across the Threads) less the O-rings, Screws, Bleeder Plugs and other hardware needed to attach it to the volute..There is another version of the face with a 2 1/2"...

This part is a Complete Jet Internal, Pentair Cyclone Jet, 5" face diameter, Swirl, 5 Scallop, Black... This will replace Sundance Intelli-Jet LX, 1999-2002   Installation Type Twist Lock Face Diameter 5" Jet Part...

This jet is obsolete but there is a replacement here: Gray 5" Scalloped Jet This Parts is a Complete Jet Internal, Pentair, Cyclone Jet, 5" face diameter, Directional, Textured, Gray.. This will replace Sundance Intelli-Jet LX,...

This Kit is an 2HP Impeller for an Executive 48 Frame Wet End up to 2HP Motor and a 56 Frame Wet End 2 HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you...

 This part is the slinger found between the impeller and wet end and the shaft going into the pump motor bearing area and is designed to sling water away from the bearing in case of a seal leak at the wet end.. Note: It has to be placed on the motor...

This Kit is an 5HP Impeller for an Executive 48 Frame Wet End up to 5HP Motor and a 56 Frame Wet End 5HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you replace...

This part is a Complete Jet Internal, Pentair, Cyclone Jet, 5" face diameter, Swirl, Textured, Gray.. This will replace Sundance Intelli-Jet LX, 1999-2002   Installation Type Twist Lock Face Diameter 5" Jet Part...

This Kit is an 3HP Impeller for an Executive 48 Frame Wet End up to 3HP Motor and a 56 Frame Wet End 3HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you replace...

This part is a Balboa Heater M7 Sensor. This Sensor comes with the wire, Connector, and The Screw down cap. It DOES NOT include the tube and the tube side mount. You will normally not need the sensor mount you would reuse it so there is no reason to...

This Kit is an 4HP Impeller for an Executive 48 Frame Wet End up to 4HP Motor and a 56 Frame Wet End 4HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you replace...

This part is a Standard Balboa Heater M7 Sensor with a 24" wire. This Sensor comes with the wire, Connector, and The Screw down cap. It DOES NOT include the tube and the tube side mount. You will normally not need the sensor mount you would reuse it so...