Sundance Hot Tub Parts

Transformer for Sundance and Jacuzzi based LX circuit boards. This 115/230 volt transformer has a step down voltage of 12 Volts. The purpose of this transformer is to energize the circuit board to power low voltage items like the processor, relay coils,...

This part is a O-Ring, Pump Housing Plug, JACUZZI, Pirahna/Theramax, 0.434"ID x 0.682"OD, .125"Cord Diameter.. Additional Information Outside Diameter .682 Inside Diameter .434 Type Standard Spa Brands Sundance/Jacuzzi

This part is an Adapter, Drain Plug, Sundance / Jacuzzi, 1/4" MPT x 3/8" Ribbed Barb, Stainless Steel, Less O-Ring.. Used on Various J-200, J-300, J-400, J-500, J-LX Series Spa Pump HeadsO-Ring is Required, Teflon Tape Not Used Click here for the...

This part is a Jacuzzi or Sundance Spa 3 7/8" Gasket found on Light Lenses, Jets and More The hole size is 3 1/8". This fits only Jacuzzi and Sundance Hot Tubs that fit these measurements. The reason they are replaced is due to extreme Chemical damage...

This part is a Wiring Adapter for a 4 5/32" Wide Jet: IX Jet Assembly with Integrated LED Light or a Waterfall..  For the jet that this adapter goes to Click this link: 4 5/32" Jet Assembly, Sundance, IX-J-400, w/Light & Wire Harness

This part is a Jacuzzi or Sundance Spa 4 1/4" Complete Light Assembly Kit. Lense, Green Cover, Blue Cover, Bulb Holder, Gasket and Nut..  The face size is 4 1/4" Some websites say 4 1/2" but ti is not. The hole size is 3 1/8". This fits only...

This part is a Jacuzzi or Sundance Spa 4 1/4" Light Assembly Kit , Lens, Gasket and Nut..  The face size is 4 1/4" Some websites say 4 1/2" but ti is not. The hole size is 3 1/8". This fits only Jacuzzi and Sundance Hot Tubs that fit these...

This part is a Sundance Spa Filter Cartridge with a 65sqft with a Castle Closed top, 2-1/16" Hole on bottom. It is 7-1/2" Wide x 14-3/4" Tall.. Diameter 7-1/2"  Length 14-3/4"  Bottom Style Open  Top Style Castle  Bottom...

This part is a Sundance or Jacuzzi, Hold Down: Filter Hook Assembly This part locks on the closed crown side of the filter to hold it in place while the open end is open locked into place by a thread nut..  For the filters and parts that...

This part is a Sundance Jacuzzi, Filter Suction Adapter Fitting, 2" MPT, Filter Pipe w/ Jam Nut.. This part threads into the wall of the hot tub and you slip the open hole end of the filter over this part then lock the crown side of the filter into...

This Kit is a Set of (4) Total Combination of the Two Standard Size 2" Heater or Pump Union Gasket (2) with a 2 1/2" Lip Center to Center and (2) with a 2 5/8" Lip Center To Center. The purpose of this Combo Kit is if you don't know...

This Kit is a Combination of the Two Standard Size 2" Heater or Pump Union Gasket (1) with a 2 1/2" Lip Center to Center and (1) with a 2 5/8" Lip Center To Center. The purpose of this Combo Kit is if you don't know which size you have...