Master Spa and Down East Hot Tub Parts

This part is a Pressure Switch Cable that is 7" long and Universal for use on most SSPA, MSPA, T-MSPA, and some Hydroquip boards..

This part is a Master Spa 8 Button Overlay for Master Spa Legend Series 2005-2012 Topside for a Three Pumps with Light. This Overlay can be used to replace your original Overlay with your brand on it as long as the button configuration works out...

This part is a 5 1/8" Master Spa, Down East or Freedom Spa Jet. This Jet is 5 1/8" across the Face Single. It features a single Hole Spinning black nozzle.  

This pump is no longer available this is the closest replacement: Pump, Circulation, Gecko AquaFlo CMCP, 1/15hp, 115v, 1-1/2", Center Discharge This part is a 115V Center Discharge G&G Olympian Circulation Pump with a 1 1/2" Suction and Pressure...

This circulation pump is found from the factory in many hot tubs and will be an easy installation for people who are handy.   This pump is a 48 frame 115V or 230V Side Discharge wet end with a 1 1/2" suction side and 1 1/2" pressure side which...

This part is a Spa Diverter (3) Piece O-Ring Kit only. This Diverter O-Ring Kit Features (2) Small O-Rings that fit on the Stem sealing the inside of the cap and (1) Large O-Ring that seals the outside of the cap and it fits many different brands The...

This part is aNew Balboa MS1600 Spa Hot Tub Board found in Master Spa Brand hot tubs.   Below Is a List of related parts to this board that you may need: Sensor Balboa M7ª 12" Temp Hi Limit 1/4" 2-pin Balboa Spa Hot Tub Heater M7 Sensor Mount...

No Longer Available and there is no replacement except a complete retrofit system..   This part is a New Balboa MAS560 Spa Hot Tub Board found in some Master Spa and Down East hot tubs. This board fits some of these 2002-2003 models, LS 650, STS,...

You are purchasing a New Balboa MAS470 Spa Hot Tub Board found in Master Spa and Down East hot tubs.  

You are Buying a Lo-Profile Drain Assembly, 3/4" Barb, Black, 1-15/16" Face Width Replacement Bottom Drain Fitting Kit found on many brands of Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one by simply adding silicon...

This Kit is a Silicone Kit & Lo-Profile Drain Assembly, 3/4" Barb, Black, 1-15/16" Face Width Replacement Bottom Drain Fitting Kit found on many brands of Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one by simply...

This part is a Complete Jet Body & Jet for a 7 5/8" Master Spa, Down East or Freedom Spa Jet. This Jet is 7 1/2" to 7 5/8" across the Face it depends on how you measure it. It features 15 black nozzles.    The plumbing...