Master Spa and Down East Hot Tub Parts

This part is a "S" Style 4 5/16" Silver Spa Diverter Handle Knob only. This Diverter Knob has a S Shaped Top and mounts on top of the Diverter Valve Stem Square that is about 7/16" Wide sticking through the diverter cap. The Diverter Valve...

  Filter, Cartridge, 30sqft, 1-1/4" Female SAE Thread, 4-3/4" Wide, 11-3/8" Tall Note: The 1 1/4" Thread is a very usual size are sure you are correct before ordering..   These are found on some Saratoga Hot Tubs.  Bottom Physical...

This part is a Magic Plastics Drain Valve that mounts through the side wall with a removable front nut to release it from the side panel.. It features a 3/4" Barb and measures about 7" Long overall.. If you need the smaller version of this valve it can...

This part is a Ozone Flash Reactor Replacement with a  3/4" Barb X 3/4" Barb connection.. It is used as a Mixing Chamber Mazzei on Ozone systems for Jacuzzi, Sundance, Master Spa and others..

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Pressure Switch Cable that is 7" long and Universal for use on most SSPA, MSPA, T-MSPA, and some Hydroquip boards..

This part is a Master Spa 8 Button Overlay for Master Spa Legend Series 2005-2012 Topside for a Three Pumps with Light. This Overlay can be used to replace your original Overlay with your brand on it as long as the button configuration works out...

This part is a 5 1/8" Master Spa, Down East or Freedom Spa Jet. This Jet is 5 1/8" across the Face Single. It features a single Hole Spinning black nozzle.  

This part is a Spa Diverter (3) Piece O-Ring Kit only. This Diverter O-Ring Kit Features (2) Small O-Rings that fit on the Stem sealing the inside of the cap and (1) Large O-Ring that seals the outside of the cap and it fits many different brands The...

You are Buying a Lo-Profile Drain Assembly, 3/4" Barb, Black, 1-15/16" Face Width Replacement Bottom Drain Fitting Kit found on many brands of Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one by simply adding silicon...

This Kit is a Silicone Kit & Lo-Profile Drain Assembly, 3/4" Barb, Black, 1-15/16" Face Width Replacement Bottom Drain Fitting Kit found on many brands of Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one by simply...