HotSpring, Watkins, Caldera, Tiger River Spa Parts

This 90 Tee Glue Kit is exclusively for HotSpring Hot Tubs made by Watkins and can be found under the name Hotspring, Solana, Tiger River, Caldera... This Item is the 90 Ell found on the pressure side of a Laing pump with a 3/8" bleeder line...

As of 11/2024 Aqua-flo has started to send this pump with a capacitor bump in an odd spot that may affect your installation, see pic 2. In light of that we are now sending this pump assembly out as a separate 10.5 Amp motor and a genuine 2.5 HP XP2...

This part is a 2.0HP Impeller fits some Jacuzzi, Sundance or Watkins Thermax Wet Ends only and would be found on a motor that is about 8.0 to 10.0 Amps on a 230V motor..... It can be found under the Name Thera-Max or Thera-Flo and is found on Jacuzzi...

This heater is the exact generic replacement for the original Watkins No Fault 4000 HTP76228 heater...This model does not include a pressure switch. If you have a gray wire with a small white or red connector on it then you have a pressure switch which...

Hot Springs retro-fit light kit with white trim. This kit replaces the old style lens with a new and improved model with white trim. Can be used on most 1989-1999 models. The spa light is visible through the light lens located in the bench seat of the...

This part is a Direct replacement sensor kit for Watkins No-Fault 4000 or 6000 heater.Includes: Temperature Sensor, Hi-Limit Sensor, and (2) Two rubber O-Rings with newer Style Connectors 2002+.  Sensor Application Spa Control Sensor...

This part is a Flow Cone Manifold is exclusively for HotSpring Hot Tubs made by Watkins and can be found under the name Hotspring, Solana, Tiger River, Caldera... This Item is the Flow Cone only but we do offer a kit in our store that features.. This is...

This Flow Cone Manifold Kit is exclusively for HotSpring Hot Tubs made by Watkins and can be found under the name Hotspring, Solana, Tiger River, Caldera... This is Kit consists of a Flow Cone Style Manifold, a 2" Heater Union and gasket, 6" of 2" Flex...

This part is a 4 1/8" Wide Diverter Cap & Handle for a 2008+ Hot Spring, Caldera, Tiger River, Watkins Diverter Valve. This Kit comes with The Cap & Handle only. The Valve these parts fit can be found on Hot Spring, Caldera, Tiger River...

This part is a Long Stem Style Repair kit for a 4 1/8" Wide Spa Hot Spring Caldera Tiger River Watkins Diverter Valve. This Kit comes with The Cap, Handle, Stem and (2) Small O-Rings and (1) Large O-Ring. The Valve these parts fit can be found on...

This part is a 1-1/2" Slip (2"Spigot) on each end Clear Check Valve found on Watkins Hot Tubs HotSpring 1989 To Present and All Tiger River Models..   

This is a Watkins Wavemaster 8000 or 8200 2.0HP Seal Kit & Impeller with a 2 1/8" Eye Width... This Impeller fits between the Face and the Volute of a XP2 Wet End found on some Watkins Hot Spring Caldera pumps with Vendor Code 4081. Impeller...