Dynasty Hot Tub Parts

  Filter, Cartridge, 30sqft, 1-1/4" Female SAE Thread, 4-3/4" Wide, 11-3/8" Tall Note: The 1 1/4" Thread is a very usual size are sure you are correct before ordering..   These are found on some Saratoga Hot Tubs.  Bottom Physical...

This filter is 13 1/2" X 4 15/16" and has a female SAE Large Thick Thread that is 2" which would really measure about 2 1/4-2 3/8" ID. This filter is found in Dynasty Bahama Tubs and others. Note: The version of this filter can vary but they are all the...

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Pressure Switch Cable that is 7" long and Universal for use on most SSPA, MSPA, T-MSPA, and some Hydroquip boards..

This video is about The Spa Guy showing you how to replace a freeze damaged pump pressure side pump union , slice to the flex pipe where it was freeze damaged... #dynastyspa #dynastyhottub    #sparepair #hottubrepair ...

This Kit is a 45° 2" Pump Union To Plumbing Connect Kit found in many Dynasty Brand Hot Tubs. The Pump Union which measures about 3" Inside the threads glues into a 2" Slip X Slip 45° fitting on one side and then a 2" Slice Valve Glues...

This kit is a Set of (2) Air Bleeder barbed plugs,(2) 3/8" x 3/8" Barb couplers, (2) 4" long pieces of 3/8" Tubing and Silicon sealer usually used on a Dynasty Hot Tub with Waterway Hot Tub Pump Face to bleed the air off the pump while filling the tub up...

This kit is a Set of (2) Air Bleeder barbed plugs and Silicon sealer usually used on a Dynasty Hot Tub with Waterway Hot Tub Pump Face to bleed the air off the pump while filling the tub up. I have seen these fittings in many brands just compare the...

This part is a 3" wide Air Valve Handle in Gray that fits some Dynasty Air Valves.  This Diverter handle Slides on the Air Control Valve Stem that measures about 1/4" and is used to operate the Air Valves and is for Dynasty Spa only. The...

This part is a 3" wide Air Valve Handle in Black that fits some Dynasty Air Valves. This handle Says Trevi instead of Dynasty but they are exactly the same.. Dynasty sent us Trevi instead of Dynasty because they  This Diverter handle...

This part is a Spa Diverter (3) Piece O-Ring Kit only. This Diverter O-Ring Kit Features (2) Small O-Rings that fit on the Stem sealing the inside of the cap and (1) Large O-Ring that seals the outside of the cap and it fits many different brands The...