Cal Spa Hot Tub Parts

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board bolts.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board Application    Balboa Water GroupManufacturers Part...

This Part is a  Cal Spa 1" Spa Hot Tub Complete Air Valve "Teardrop Style". The Valve Tear Drop Cap Width is approx. 3" and the Hole size in the tube would be 1 5/8" with a 1" slip plumbing commention on the bottom..   For help please see our...

You are buying a Cal Spa 7000 or 9000 Heater M7 foam type Sensor. This Sensor comes with the wire, Connector, and The foam sensor. It DOES NOT include the tube, the tube side mount or the pull ties. When this sensor is bad it will generally cause a SN...

You are Buying a Cal Spa 1" Spa Hot Tub Air Valve " Cap Only". The Valve Tear Drop Cap Width is approx. 3" and the Hole in the Cap is approx. 1/4". Compare the measurements to be sure this is correct. The list on this Knob only is $22.99. NOTE: This...

Power-Right Pump Impeller Note: This Impeller is Obsolete so I have only (1) left.. This is the Reverse Side Closed face impeller made for the Power-Right PR420-5R Dually spa pumps. Seals & kits for this Impeller can be found here: 201...

Power-Right Pump Impeller Note: This Impeller is Obsolete so I have very few left.. Closed face impeller made for the Power-Right PR420-5F spa pumps. Seals & kits for this Impeller can be found here: 201 Seals Impeller Type    Closed...

You are buying a Cal Spa Hot Tub Silver Neck Pillow for Some Cal Spa Hot Tubs. It is 11" long Edge to Edge, 5 1/8" Wide on the edge top to bottom and it has 2 pins that are 9" between the pins . It is silver in color and has bumps.   We...

This part is a Cal Spa Hot Tub Silver Wing Pillow found over neck jets for Some Cal Spa Hot Tubs. It is 16 3/8" long wing tip to tip, 3" Wide in the center it has 2 pins that are 8 1/2" between the pins . It is silver in color and has bumps...

You are buying a Cal Spa Hot Tub Dark Gray Neck Pillow for Some Cal Spa Hot Tubs that usually has 1481 cast into the back of the pillow. It is 11 1/8" long Edge to Edge, 5" Wide on the edge top to bottom and it has 2 pins that are 9" between the...

This part is discontinued by the manufacturer.. This Part is a Power-Right Pump Face Plate only.. Related Parts: Impeller, Power-Right, 9089X/504, 2.5ohp/5spl Face Plate, Power-Right, Cal Spa, Power Right, Pump, Wet End, Volute, 5 Bolt, 2" X 2"...

This item is a (4) Way Barbed Coupling used to couple 3/8" ID hose together. 3/8 Inch Barb X 3/8 Inch Barb through and a tee Barb Coupling 3/8" barb and 3/8" barb... This part is used on pump bleeder systems many time where the bleeders are attached...

This Cal Spa filter is a 25 Square Foot Filter Cartridge that is 4-15/16" Outside Diameter x 13-5/16" in Length. It has a hole in the top and the bottom that are 2 1/8". Don't just order this filter though be sure it is the correct size for your Cal Spa....