Cal Spa Hot Tub Parts

Power-Right Pump Impeller Note: This Impeller is Obsolete so I have very few left.. Closed face impeller made for the Power-Right PR420-5F spa pumps. Seals & kits for this Impeller can be found here: 201 Seals Impeller Type    Closed...

You are buying a Cal Spa Hot Tub Silver Neck Pillow for Some Cal Spa Hot Tubs. It is 11" long Edge to Edge, 5 1/8" Wide on the edge top to bottom and it has 2 pins that are 9" between the pins . It is silver in color and has bumps.   We...

This part is a Cal Spa Hot Tub Silver Wing Pillow found over neck jets for Some Cal Spa Hot Tubs. It is 16 3/8" long wing tip to tip, 3" Wide in the center it has 2 pins that are 8 1/2" between the pins . It is silver in color and has bumps...

You are buying a Cal Spa Hot Tub Dark Gray Neck Pillow for Some Cal Spa Hot Tubs that usually has 1481 cast into the back of the pillow. It is 11 1/8" long Edge to Edge, 5" Wide on the edge top to bottom and it has 2 pins that are 9" between the...

This part is discontinued by the manufacturer.. This Part is a Power-Right Pump Face Plate only.. Related Parts: Impeller, Power-Right, 9089X/504, 2.5ohp/5spl Face Plate, Power-Right, Cal Spa, Power Right, Pump, Wet End, Volute, 5 Bolt, 2" X 2"...

This item is a (4) Way Barbed Coupling used to couple 3/8" ID hose together. 3/8 Inch Barb X 3/8 Inch Barb through and a tee Barb Coupling 3/8" barb and 3/8" barb... This part is used on pump bleeder systems many time where the bleeders are attached...

This Cal Spa filter is a 25 Square Foot Filter Cartridge that is 4-15/16" Outside Diameter x 13-5/16" in Length. It has a hole in the top and the bottom that are 2 1/8". Don't just order this filter though be sure it is the correct size for your Cal Spa....

This part is a 4.0KW Titanium (Best) Heater Element.  This Heater Element features the bend in the back of the element needed to fit the Balboa M-7 heater tubes and has the standard 1-1/4" spacing between the element terminals, center to center...

This video is about The Spa Guy showing How To diagnose a FLO Code on a Catalina Spa with Balboa Controls.. it is a similar process on other brands as well...    #sparepair #hottubrepair spaguy #thespaguy Save Save Save Save

In this Video The Spa Guy goes through the repair and seal replacement on a Cal Spa Power Right pump and motor... Save

This part is a Hot Tub Replacement Bottom Drain Inside Wall Fitting with a 3/4" slip fitting which measures about 1" I.D.. This part is on the foam side of the tub and the Fitting screws into this fitting.. You have to stand the hot tub up and dig into...

This video is about The Spa Guy showing How To Remove a Heater Element where the nuts are spinning in the tube and will not turn off...... it is a similar process on all brands... Save