Cal Spa Hot Tub Parts

This part is a complete Heater, Flo Thru, Balboa M7, 800, 825, 15" x 2", 230v or 115v , 4.0kW, with Sensors..  This heater tube has a stud on the top and bottom make sure yours has them too.. This heater DOES include m7 sensors and split nuts,...

This part is a Filter Basket found in some older Cal Spas.. Basket Type Skimmer Application Manufacturer Waterway Application Model Top Mount Skimmer Basket Height 5-5/8" Bottom Outside Dimension 5" Top Inside...

Note: This heater IS NOT Exactly like the original as the original is not longer avaliable.. This will work in place of the old one but it is not going to jump in it will require effort and mechanical ability.. If you are not willing to apply effort in...

This part is a Cal Spa Replacement Version of the Genesis 7000 or 9800 System Retrofit Topside that is replacing the original topside that was scrapped because it had so many issues. Cal Spa replacement for Cal Spa dash board style topside control...

This Filter is 14-15/16" wide x 14 7/8" tall it has 2 1/8" holes on the top and bottom.   Application Fountain Valley Spas, Martec/Sonfarrel, Santana, Sonfarrel/Advantage Bottom Physical Dimension 2-1/8" Bottom...

This part is a Circuit Board, Balboa, VS501Z, Duplex Digital, 8 Pin Phone Cable w/Circ Option.. As of 2024 new VS501 circuit boards will come with the plug and click female heater adapter installed. It can be removed and you reuse your old wiring or see...

This part is a Hot Tub Replacement Bottom Drain Inside Wall Fitting with a 3/4" slip fitting on each end which measures about 1" I.D.. This part is on the foam side of the tub and the Fitting screws into this fitting.. You have to stand the hot tub up...

This part is a Complete Cal Spa Peanut topside control panel...Button Pattern: Temp, Light, Jets, Option8 Pin 7' phone style connector4-1/2" x 9-3/4" Overall Size   4 Button, LED Display w/7' Cord Overlay Included - Yes Plug Type - 8...

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This kit is a Set Of (4) Bolts and Grommets For A Cal Spa Hot Tub Front Access Panel Door.  The Bolt is 2" In Length And The Grommet Has 3/4" Diameter.  

This part is a Cal Spa Safety Suction Tee Fitting that has a 2" Pump Union that would measure about 3" Inside Diameter X 2" Slip Fitting that is 2 3/8" Inside Diameter with a 1/8" MPT Tap on the top to receive a Safety Suction on Top.. Note: The Cal Spa...