Cal Spa Hot Tub Parts

This part is a Cal Spa Cluster Storm, Jet Internal, Waterway, 2" face diameter, Textured 3 Swirl..

This part is a Cal Spa Cluster Storm, Jet Internal, Waterway, 2" face diameter, Textured 3 Scallop..

This part is a Diverter Kit with a Stem, Silver "S" Style 4 5/16" Long Diverter Handle, Graphite 3 11/16" Graphite Cap & O-ring Kit. This Diverter Knob has a S Shaped Top and mounts on top of the Dive

This part is a Reinforced "S" Style 4 5/16" Gray Spa Diverter Handle Knob only. This Diverter Knob has a S Shaped Top and mounts on top of the Diverter Valve Stem Square that is about 7/16" Wide stic

This part is a Silver "S" Style 4 5/16" Long Diverter Handle and Graphite 3 11/16" Graphite Cap & O-ring Kit only. This Diverter Knob has a S Shaped Top and mounts on top of the Diverter Valve St

This part is a Silver "S" Style 4 5/16" Long Diverter Handle and Graphite 3 11/16" Graphite Cap only. This Diverter Knob has a S Shaped Top and mounts on top of the Diverter Valve Stem Square that is

This part is a "S" Style 4 5/16" Silver Spa Diverter Handle Knob only. This Diverter Knob has a S Shaped Top and mounts on top of the Diverter Valve Stem Square that is about 7/16" Wide sticking thro

  Filter, Cartridge, 30sqft, 1-1/4" Female SAE Thread, 4-3/4" Wide, 11-3/8" Tall Note: The 1 1/4" Thread is a very usual size are sure you are correct before ordering..   These are found on some...

This part is a Filter Basket found in some older Cal Spas..

This Filter is 14-15/16" wide x 14 7/8" tall it has 2 1/8" holes on the top and bottom.  

This part is a Hot Tub Replacement Bottom Drain Inside Wall Fitting with a 3/4" slip fitting on each end which measures about 1" I.D.. This part is on the foam side of the tub and the Fitting screws...

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade..