Cal Spa Hot Tub Parts

This part is a Cal Spa Cluster Storm, Jet Internal, Waterway, 2" face diameter, Textured 3 Scallop.. Note: This is a 2” Waterway Cluster Storm Jet.. Also these jets look very similar to CMP Typhoon 200 Series jets but they do not interchange so...

This part is a Diverter Kit with a Stem, Silver "S" Style 4 5/16" Long Diverter Handle, Graphite 3 11/16" Graphite Cap & O-ring Kit. This Diverter Knob has a S Shaped Top and mounts on top of the Diverter Valve Stem Square that is...

This part is a Reinforced "S" Style 4 5/16" Gray Spa Diverter Handle Knob only. This Diverter Knob has a S Shaped Top and mounts on top of the Diverter Valve Stem Square that is about 7/16" Wide sticking through the diverter cap. The...

This part is a Silver "S" Style 4 5/16" Long Diverter Handle and Graphite 3 11/16" Graphite Cap & O-ring Kit only. This Diverter Knob has a S Shaped Top and mounts on top of the Diverter Valve Stem Square that is about 7/16" Wide...

This part is a Silver "S" Style 4 5/16" Long Diverter Handle and Graphite 3 11/16" Graphite Cap only. This Diverter Knob has a S Shaped Top and mounts on top of the Diverter Valve Stem Square that is about 7/16" Wide sticking through the...

This part is a "S" Style 4 5/16" Silver Spa Diverter Handle Knob only. This Diverter Knob has a S Shaped Top and mounts on top of the Diverter Valve Stem Square that is about 7/16" Wide sticking through the diverter cap. The Diverter Valve...

  Filter, Cartridge, 30sqft, 1-1/4" Female SAE Thread, 4-3/4" Wide, 11-3/8" Tall Note: The 1 1/4" Thread is a very usual size are sure you are correct before ordering..   These are found on some Saratoga Hot Tubs.  Bottom Physical...

This part is a Filter Basket found in some older Cal Spas.. Basket Type Skimmer Application Manufacturer Waterway Application Model Top Mount Skimmer Basket Height 5-5/8" Bottom Outside Dimension 5" Top Inside...

This Filter is 14-15/16" wide x 14 7/8" tall it has 2 1/8" holes on the top and bottom.   Application Fountain Valley Spas, Martec/Sonfarrel, Santana, Sonfarrel/Advantage Bottom Physical Dimension 2-1/8" Bottom...

This part is a Hot Tub Replacement Bottom Drain Inside Wall Fitting with a 3/4" slip fitting on each end which measures about 1" I.D.. This part is on the foam side of the tub and the Fitting screws into this fitting.. You have to stand the hot tub up...

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...