Hot Tub Parts by Tub Brand

This part is a 3.0HP Power-Right Pump Impeller that would be found on a motor with about 12.0 Amps at 230V.. Closed face impeller made for the Power-Right 3.0ohp/6.0thp spa pump. Ra

This part is a Black 4" Spa Diverter Handle Knob only.  This Diverter Knob mounts on top of the Diverter Valve Stem Square that is about 7/16" Wide sticking through the diverter cap. The Diverter...

This is a very unusual Air Manifold we have found in Sundance brand Hot Tubs nut can be found in others as well.. It is a 16-port manifold with (16) 3/8" barbs and 1-1/ 2" slip x 1-1/2"spigot or...

This filter is 9 1/4" X 4 15/16" and has a female SAE Large Thick Thread that is considered 1-1/2" which would really measure about 1-11/16". This filter is found in some Four Winds Tubs and others...

This filter fits Some Caldera and other Watkins Hot Tubs.. The Cartridge is 75 sqft, It features a 2-11/16" hole in the bottom and is 7" wide by 14-3/4" tall.. Diameter    7"Length    14-3/4"Top...

This part is a Filter Cartridge, 50sqft, 2-11/16"ob, 7" Wide, 10-3/4" Tall, found on some Watkins Caldera hot tubs..

This parts is an Artesian, Resort Series, Filter, Cartridge, 50sqft, 2" male pipe thread, 6-3/4" Wide, 8" Tall.. Note The small filter found in the center

This part is a Vacuum Switch like you will find on some  Cal Spas in the suction side of the pump. Specs V4001P-DX Replacement, 21A, 1/8"mpt. For a switch like the original click this link:

This Part is a Surface Mount Style HI LIMIT: Single Pole Single Throw THERMAL FUSE Auto Reset (With NO CAPILLARY)This Hi Limit Surface mount surface mounts to the heater in a spot where it can read...

This part is a Temperature Sensor found in some Jacuzzi J-Series and Sundance hot tubs that have Curled Finger Style connector..  See the pictures for the Curley finger&nb

This valve cap has been discontinued and we are working on a modern replacement. Until then you can replace the complete valve with ease using one of our waterfall kits. See below