Hot Tub Parts by Tub Brand

This part is a Clip that hold the  Jacuzzi Spa Trap, Mesh Skimmer Bag into place inside the filter housing. Fits most J-300 Series, 2002 and newer and here is a link to the filter for this tub too Jacuzzi Premium 2002+ Filter Skimmer Bag has 6...

This is a 5-1/4" FLUIDIX-INTELLI-JET WITH ESCUTCHEON for Sundance Hot Tubs.. This jet is very specific to Sundance brand hot tubs only do not order for another brand..

This Filter is a 40 Square Foot Filter Cartridge for a Dynasty Hot Tub that is 6" Outside Diameter x 8 1/4" in Length. It has a 1 1/2" SAE Threaded Fitting which is a Thick Thread that measures about 2" outside diameter of the threads. SAE Threads are...

NOTE: This part is obsolete but we do have an alternative camp that will work but it is Dark Graphite Gray. If you order this Teardrop cap you will get the 6 spoke cap instead.. This part is a Cal Spa 1" Spa Hot Tub Air...

Power-Right Pump Impeller Note: This Impeller is Obsolete so I have only (1) left.. This is the Reverse Side Closed face impeller made for the Power-Right PR420-5R Dually spa pumps. Seals & kits for this Impeller can be found here: 201...

Power-Right Pump Impeller Note: This Impeller is Obsolete so I have very few left.. Closed face impeller made for the Power-Right PR420-5F spa pumps. Seals & kits for this Impeller can be found here: 201 Seals Impeller Type    Closed...

This part is a 3 1/4" JACUZZI® Premium Mini Power Pro FX Jet Kit for 2004+ hot tubs..     Jacuzzi Spa Mini PowerPro FX Jet Without Stainless Steel Escutcheon. Jet Face Measures 3 1/4 Inches Across. This Jet Was Introduced In...

You are buying a Cal Spa Hot Tub Silver Neck Pillow for Some Cal Spa Hot Tubs. It is 11" long Edge to Edge, 5 1/8" Wide on the edge top to bottom and it has 2 pins that are 9" between the pins . It is silver in color and has bumps.   We...

This part is a Cal Spa Hot Tub Silver Wing Pillow found over neck jets for Some Cal Spa Hot Tubs. It is 16 3/8" long wing tip to tip, 3" Wide in the center it has 2 pins that are 8 1/2" between the pins . It is silver in color and has bumps...

You are buying a Cal Spa Hot Tub Dark Gray Neck Pillow for Some Cal Spa Hot Tubs that usually has 1481 cast into the back of the pillow. It is 11 1/8" long Edge to Edge, 5" Wide on the edge top to bottom and it has 2 pins that are 9" between the...

This Waterfall or Neck Jet Control Stem is Used in Waterway Top Access 100% shut-off valves 1". This valve has a piece of rubber on the backside to complete the seal..  Click on the links below for related part:  Spa Hot Tub 1" Waterfall or...

This part is a 2.0HP Impeller fits some Jacuzzi, Sundance or Watkins Thermax Wet Ends only and would be found on a motor that is about 8.0 to 10.0 Amps on a 230V motor..... It can be found under the Name Thera-Max or Thera-Flo and is found on Jacuzzi...