Heaters and Related Parts

This part is a Heater Tailpiece, 2 1/2"mbt x 2" Slip.. The threaded side measures about 3 5/8" edge to edge and the Slip side measures about 2 3/8" Inside Diameter..  For the gasket that works with this Union click this Link: 2 1/2" Spa Hot Tub...

This housing alone is not longer available but a complete heater is available click here for that heater: 90° Heater Assembly, Brett Aqualine, Plastic Manifold, 5.5kW, 230V, w/Hi-Limit, P-Switch and Assorted Plumbing Fittings   Brett...

This Kit features a 1 1/2" Threaded Split Nut that goes over the flange of a 1 1/2" Heater Flow Through style Tube... And a 1 1/2" Threaded x 1 1/2" Slip PVC Heater unions as well as a gasket that fits between the union and the tube flange... This kit is...

Tailpiece, 2"mbt x 1-1/2"s/2"spg, w/Split Nut, Heater   Heater Union Part Type Tailpiece First Plumbing Connection Size 2" First Plumbing Connection Type Male Buttress Thread (mbt) Second Plumbing Connection Size 1-1/2",...

This part is a Standard 3.0KW Heater Element 115v or 230V that features the bend in the back of the element needed to fit the Balboa M-7 heater tubes. This also fits Gecko, ACC, and most other standard Hot Tub Heater Tubes.   This part...

This Part is a Surface Mount Style HI LIMIT: Single Pole Single Throw THERMAL FUSE Auto Reset (With NO CAPILLARY)This Hi Limit Surface mount surface mounts to the heater in a spot where it can read what the actual water temperature is flowing through the...

5"x 5"Flange ElementWelded construction most commonly used in plastic manifolds such as Brett Aqualine, Premier, Allstate, and Hot Water products. Dual 5/16" thermowells, studs for thermodisc, 1/8"npt pressure switch tap, hole for current collector bolt...

This item is a 1/8" MPT Brass Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole or...

This part is a Center Mount 5.5KW Incoloy Heater Element for 230V or 115V Applications. Center mount means the holes for the electrodes are in the center of the tube to to one side or the other.. This is a very rare style but they are out there....

This part is a Jumper Strap Set of (2) Kit to connect the heater to the circuit board on Balboa LE and Value Systems. Measures 1-3/8" x 13/16" Circuit Board Application    Balboa Water GroupCircuit Board Model    LE, Value...

This item is a 1/8" MPT Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole or the...