Heaters and Related Parts

This part is a Set of 4" Jumper Wires that would go from a standard heater element Electrode Tab to the board bolts.. These can be used on 4.0kw to 5.5kw elements to transfer voltage from the circuit board to your heater. Uses a 10 gauge wire...

This item is a Modified 2 1/2" Heater Union Tailpiece with a Pressure Switch Tap and Gasket that is used on may heater tubs that measure about 3" inside diameter of the tube.. It also has a 90 degree 1" Barb fitting.. This Union has had a Pressure Switch...

This part is a 2 1/2" Heater Split Nut with a Gasket which measures 3 9/16" Inside Diameter of the threads and 3" inside the ceneter part that wraps around a heater tube or body. The Heater Flange Split Nut mounts to the heater tube using 2 screws to...

This part is a 4.0KW Titanium (Best) Heater Element.  This Heater Element features the bend in the back of the element needed to fit the Balboa M-7 heater tubes and has the standard 1-1/4" spacing between the element terminals, center to center...

The Spa Guy is talking here about the ins and outs of wiring a GFCI Breaker. Please consult your local codes for actual wiring rules...  #sparepair #hottubrepair  #hottubhowto Save

The Spa Guy is talking here about the ins and outs of wiring a 3 Wire Jacuzzi Premium, Sundance, Vita Spa, Keys Backyard or other brand instead of the normal 4 wire GFCI Breaker system...

In this video The Spa Guy shows actual voltage in the water on a hot tub and what caused it. a Missing ground on the GFCI box when the hot tub was wired!! Once again The Spa Guy Saves the Day!! Your Hot Tub Super Hero  #sparepair #hottubrepair...

This video is about The Spa Guy teaching you the basics of GFCI Hot Tub Wiring and the ins and outs of wiring a Hot Tub...  #sparepair #hottubrepair  #hottubhowto Save

This video is The Spa Guy teaching you how to Diagnose a New Wire Up Situation where you just wired your hot tub up and it is tripping the breaker and it is either a new tub or it is used and ran fine at the last location...... Save

This video is about The Spa Guy diagnosing a Breaker Tripping on a Hot Tub With Hydro-Quip Controls... How To Replace the Heater Element and final diagnostic verification of operation.... Save

This video is about The Spa Guy showing How To Remove a Heater Element where the nuts are spinning in the tube and will not turn off...... it is a similar process on all brands... Save

This Part is a 5.5KW Titanium Heater Element with (2) Heater Union Gaskets and a 1/2Oz Tube of Special Hot Tub Formulated Silicon Sealer to Seal the Threads. This Heater Element features the bend in the back of the element needed to fit the Balboa M-7...