Electronic Control Systems and Parts

This part is obsolete..but we have a better option here: Jumper Wire, Heater Element, 10 gauge x 4", Board to Heater Jumper Strap to connect the heater to the circuit board on Balboa EL, GL, and Value systems. 2 required.   Heater Part...

This part is a Sensor, Hi Limit, HydroQuip, 18", 1/4"diameter, 2-pin, After 5/03, 6200, 6220, 6230, 6330, 7500, 9700 series control systems..   Sensor Application Spa Control Sensor Type Hi...

Mini Size Pump Plug 2 Speed48" long, 14/4 AWG

This part is an Enclosed Circuit Board Relay for 15v DC boards like you would find on Jacuzzi, Sundance or others.. Coil contacts are on bottom of relay at PC board. Trace saver tabs are available at top of relay Coil Voltage...

This Temperature Sensor Set has 1/4" probe widths on both probes.. This set usually found on tubs with no heater that uses a firestick or heat jacket to heat not a real heater... I have seen these on Dreammaker and other brands... The temp probe is...

This is a Thermcore Plastic replacement sleeve. The Stainless Steel version is no longer available.. Sensing Bulb Size 5/16" Depth 4" Plumbing Connection Size "A" 1/2" Plumbing Connection Type "A" Male Pipe Thread (mpt)

This sensor is no longer available.. Temperature Sensor

This part is No Longer Available and there is no replacement..   Hydrothermix Pump UnionsFor pump without molded ports

This part is a Vacuum Switch like you will find on some  Cal Spas in the suction side of the pump. Specs V4001P-DX Replacement, 21A, 1/8"mpt. For a switch like the original click this link: PresAirTrol Style Vacuum Switch This is a normally open...

This part is the Cord Side Male AMP Connector that houses (3) Male Pins.. The Pins are not included..   Terminal Type AMP Terminal Style AMP Plug Housing Male Number of Connections 3 Terminal Amperage 20A The other...