Electronic Control Systems and Parts

Terminal Block Spade Cluster Jumper Repair Solution for Damaged Circuit Board Terminal Blocks This Terminal Block Spade Cluster Jumper is designed to solve a common and frustrating proble

Caldera Hi-Limit sensor used on the Advent control systems from 2002 - current. This sensor is found mounted to your heater and detects high heat conditions to protect the heater from running dry or...

OEM Caldera temperature sensor with 3/8" bulb. This sensor is normally found mounted into a sensor well and makes direct contact with the spa water. On the other end it plugs into the circuit board...

AMP cable splitter for use with Gecko or Balboa spa packs. This 14/3 splitter is commonly used for the circulation pump and the ozonator to share one receptacle on the main circuit board. It has a 6"...

Sundance and Jacuzzi Flow Switch for 2006-2009 models. Jacuzzi used this switch on all 400 Series models 2006-2009 and in various Sundance models, including in ground units. Includes the tee with...

Balboa Expander circuit board used to add a 2 speed pump output to the VS520SZ, VS520DZ, BP7, LPI501ST, and BP501 based circuit boards and spa packs. This board is found mounted on top of the heater...

Temperature sensor for the Jacuzzi J-400 and J-1000 models from 2010 - current that uitilize the Nidec Spa pack that has the different colored rubber molded plugs, called a DSMT plug. This sensor has...

Balboa "Y" Splitter used to add an additional Pump # 4 on BP spa packs and control systems such as the BP7 and BP2000. To utilize this splitter you plug the male end into the Pump 2 port, go into the...

This Plumbing & Glue kit is used to change from a Energy Saver Remote Heater Control Heater to a Standard Heater and is the Plumbing Kit Retrofit fit for some

This part is a 72" AMP Style 3 Wire Cord With Male Plug that is used on a 1 speed pump or blower..

This part is a 60" AMP Style 3 Wire Cord With Male Plug that is used on a 1 speed pump or blower.. Note: To use this cable with a blower you will cut the spade co

This part is a Amp Cord, Pump 1, 2-Speed, 4-Pin Amp, 14/4, 96" Long, Plug Attached, w/Terminated Ends.