Digital Control Systems and Parts

Topside adapter plate for the ACC Smartouch and Modpack KP1000, KP1000DP and the KP1005 models. This adapter plate will cover a larger hole when installing a new retro-fit control system upgrade. Outside Measurements = 9" x 4" Inside Measurements = 4.65"...

Transformer for Sundance and Jacuzzi based LX circuit boards. This 115/230 volt transformer has a step down voltage of 12 Volts. The purpose of this transformer is to energize the circuit board to power low voltage items like the processor, relay coils,...

This part is a 3 Terminal Power Block found on some Jacuzzi or Sundance Control pack and board set ups.. This part is found in some Jacuzzi Premium J-220, J-210, J-315, J-310, 2004 J-325, and 2008+ J-325 models and some Sundance 800 or 850 systems....

This part is a Terminal Block 4 Position 50A 230V.. that fits some Sundance and Jacuzzi control systems with (4) Tabs to connect the board to the components.. This Terminal Block is 3 7/8" wide x 1 13/16" tall..

This part is a Circuit Board Kit, Expander for Balboa VS or EL Systems for the Blower circuit, w/10 Amp Fuse, w/Cables.. Please Note: Circuit boards are a final sale and cannot be returned Circuit Board Control Type Spa Control Circuit Board...

This part is a Balboa Heater M7 Sensor with a 82" wire found in some HydroQuip Systems using Balboa Boards.  Sensor Application    Spa ControlSensor Type    Hi Limit, Temp or Hi Limit,...

This part is a Balboa Heater M7 Sensor with a 46" wire found in some HydroQuip Systems using Balboa Boards.  Sensor Application    Spa ControlSensor Type    Hi Limit, Temp or Hi Limit,...

This kit is a (1) Standard Balboa Board Replacement Repair Relay along with (1) Spade to Spade Jumper and (1) Spead to Loop Jumper used to do a beef up Jumper Style repair on Some Balboa VS and EL Boards and others...  When replacing board relays...

This tool can be used to drill out the hole in the boards when changing out relays.. After you desolder a relay you can use these bits to open the holes up then slide the new relay in the holes and solder.. This also helps you to prevent damage to the...

This kit is a Set of (2) Standard Balboa Board Replacement Repair Relays along with (3) Spade to Spade Jumpers used to do a beef up Jumper Style repair on Some Balboa BP Boards and others...  When replacing board relays you may need this drill bit...

This part is a Ground Bar found on many Balboa Brand Spa Hot Tub packs as well as some Gecko SSpa and Mspa packs.

This part is a Heater M7 Sensor with a 31" wire found in Jacuzzi Premium J series 2016 to current.  Note: This sensor does not have the nut and washer on it so it will only work with Jacuzzi Premium hot tubs..   Application Balboa...