Pressure Switchs

This part is an Adapter, Drain Plug, Sundance / Jacuzzi, 1/4" MPT x 3/8" Ribbed Barb, Stainless Steel, Less O-Ring.. Used on Various J-200, J-300, J-400, J-500, J-LX Series Spa Pump HeadsO-Ring is Required, Teflon Tape Not Used Click here for the...

Brass Fitting that fits an 1/8" MPT Jacuzzi heater fitting on one side a 3/8" ID tube on the other side. I have seen these in Jacuzzi Premium Trombone Heaters to attach the heater to the bleeder system though there are many applications this can be used...

The Spa Guy is talking here about the ins and outs of wiring a GFCI Breaker. Please consult your local codes for actual wiring rules...  #sparepair #hottubrepair  #hottubhowto Save

In this video The Spa Guy shows actual voltage in the water on a hot tub and what caused it. a Missing ground on the GFCI box when the hot tub was wired!! Once again The Spa Guy Saves the Day!! Your Hot Tub Super Hero  #sparepair #hottubrepair...

This video is about The Spa Guy teaching you the basics of GFCI Hot Tub Wiring and the ins and outs of wiring a Hot Tub...  #sparepair #hottubrepair  #hottubhowto Save

This video is The Spa Guy teaching you how to Diagnose a New Wire Up Situation where you just wired your hot tub up and it is tripping the breaker and it is either a new tub or it is used and ran fine at the last location...... Save

Brass Fitting that fits an 1/8" MPT heater fitting on one side a 1/8" ID tube on the other side. I have seen these in AP-1400 Len Gordon Pack to attach the heater to the pressure though there are many applications this can be used for.

Series 3000 Pressure SwitchThis switch is found in many spa applications where a durable switch is required. It is rated at 25 amps and is available in a variety of mounting stylesStailness pan material. Optional plastic pan to prevent corrosion

Tinytrol Pressure Switch1/8"NPT, no panel mount, 2psi, 21 amp, SPDT

This item is a 1/8" MPT Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole or the...

This part is a Series 4000 Pressure Switch, 25A, Tecmark, 1/8"mpt, SPDT, Plastic..  The number on your original switch would be 4015P.. Manufacturer Tridelta/Tecmark Switch Type Pressure Pressure Switch Rating 1 to 11 PSI Rating 1 to 11...

Series 3000 Pressure SwitchThis switch is found in many spa applications where a durable switch is required. It is rated at 25 amps and is available in a variety of mounting stylesStainless pan material. Optional plastic pan to prevent corrosion