Air Button Style Analog Systems and Parts

This part is an Adapter, Drain Plug, Sundance / Jacuzzi, 1/4" MPT x 3/8" Ribbed Barb, Stainless Steel, Less O-Ring.. Used on Various J-200, J-300, J-400, J-500, J-LX Series Spa Pump HeadsO-Ring is Required, Teflon Tape Not Used Click here for the...

This kit is a (1) Standard Balboa Board Replacement Repair Relay along with (1) Spade to Spade Jumper and (1) Spead to Loop Jumper used to do a beef up Jumper Style repair on Some Balboa VS and EL Boards and others...  When replacing board relays...

This tool can be used to drill out the hole in the boards when changing out relays.. After you desolder a relay you can use these bits to open the holes up then slide the new relay in the holes and solder.. This also helps you to prevent damage to the...

This kit is a Set of (2) Standard Balboa Board Replacement Repair Relays along with (3) Spade to Spade Jumpers used to do a beef up Jumper Style repair on Some Balboa BP Boards and others...  When replacing board relays you may need this drill bit...

Brass Fitting that fits an 1/8" MPT Jacuzzi heater fitting on one side a 3/8" ID tube on the other side. I have seen these in Jacuzzi Premium Trombone Heaters to attach the heater to the bleeder system though there are many applications this can be used...

This part is a 3 Wire Thermostat replacement found in some Air Button Topsides that require 3 wires to operate.. Single pole rated at 25 amps with max temp rating at 107°F. Best results are obtained when the bulb is installed in a dry well or groove...

This item is a 1/8" MPT Plastic Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole...

This Part is a Heater Indicator Light 1/4" mounting hole used to indicate a heater or pump working in a 115V system.. Indicator Light Type    Two-PieceColor    RedVoltage   115vHole Size    1/4"

This Part is a Heater Indicator Light 1/4" mounting hole used to indicate a heater or pump working in a 230V system.. Indicator Light Type    Two-PieceColor    RedVoltage    230vHole Size  ...

This part is for a Set of (2) Standard Balboa Board Replacement Repair Relay made by Zettler. This Relay is the standard relay found on most Balboa Boards but it has double tabs on it so you can add jumpers from the tabs to the feed and load side of the...

This part is a Balboa 115V Control System used in Garden Style Bath Tubs.. You plug the controller into a wall plug, then plug the 115V Bath pump into the controller then mount the button and plug the wire in from the mounted button and the button will...

This part is a 115V Control System used in Garden Style Bath Tubs.. You plug the controller into a wall plug, then plug the 115V Bath pump into the controller then mount the button and plug the wire in from the mounted button and the button will control...