Hot Tub Parts of America

You are buying a 5 HP 56 Frame Waterway Executive 2 1/2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is...

You are buying a 5 HP 56 Frame Waterway Executive 2 1/2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face, Wear Ring, Bleeder Barb and Silicon.     ...

Waterway Teleweir Inner Pipe and basket sub assembly for 50 sq ft filters. This part installs into the canister around the filter and is the main portion that floats up and down with the water level...

Waterway Teleweir Upper weir for the sub assembly. This part sits on top of the sub assembly and draws water in through its fins when the pump runs. The most common failures of this part are broken...

This part is a Seal Kit for all Waterway Viper Pumps which includes a seal, (1) Bearing, install tool and (1) 1/2Oz Tube of The Professor's Silly Juice a Specially Formulated for Hot...

This part is a Seal Kit for all Waterway Viper Pumps which includes a Seal, (2) Bearing, Install tool and (1) 1/2Oz Tube of The Professor's Silly Juice a Specially Formulated for Hot...

This part is a Seal Kit for all Waterway Viper Pumps which includes a seal, install tool, (1) 1/2Oz Tube of The Professor's Silly Juice a Specially Formulated for Hot Tubs Silicon...

Waterway jet body for their whirlpool / volcano jet. This jet body is found either in the floor of the spa shooting straight up acting as a Volcano or on the side wall of the spa creating a whirlpool...

This part is a Replacement Diffuser for a 5"- 5 1/2" Wide Faced Storm Jet made by Waterway. Watch the below videos for more information on this type diffuser and installation instructions as well....

This is a Watkins Wavemaster 9000 or 9200 2.5HP Seal Kit & Impeller with a 2 1/8" Eye Width. This Impeller fits between the Face and the Volute of a XP2 Wet End found on some Watkins Hot Spring...

This Parts is a NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2"...

This is a Watkins Wavemaster 8000 or 8200 2.0HP Seal Kit & Impeller with a 2 1/8" Eye Width... This Impeller fits between the Face and the Volute of a XP2 Wet End found on some Watkins Hot Spring...