XP2 1.5 HP 2 1/8" Eye Impeller & Seal Kit Aqua-Flo 230V 9 Amp or 115V 14 Amp

(No reviews yet) Write a Review

SKU:: HTP91694BKEasealkit
Shipping:: Calculated at Checkout

MSRP: $58.99

$48.99

— You save $10.00

Current Stock: 940

Quantity:

Description

Description

This is a 1.5HP Seal and Impeller Kit.. The Impeller has a 2 1/8" Eye width for an Aqua-Flo 48 or 56 Frame Wet End 1.5HP Motor would be about 9.0 Amps on high speed at 230V or 14.0 Amps on High at 115V.

Note: The three things you need to know to get the correct Aqua-Flo XP2 or XP2e Impeller is the Eye Width, Voltage and Amperage.. Use the chart with the Voltage and Amperage to determine the HorsePower.. DO NOT rely on the HorsePower on the pump it is usually “Overrated” not accurate.. See Chart Below.. The Eye Size Choices are 2 ⅛”, 2 ⅜” and 2 ⅝”..

This Impeller fits between the Face and the Volute of an Aqua-Flo XP2 Wet End.

This Impeller uses PS-200 Seal kits that can be found Click Here.

Note: This Bearing has a 17mm bearing center hole; some motors on Aqua-Flo pumps have a 15.9mm bearing center hole so measure before ordering.. Put a Note in the space during check out and we will ship a 15.9mm instead..

115V Chart Below

3/4HP 8-9 Amps

1HP 11-12 Amps

1.5HP 16-17 Amps

2HP 19-20 Amps. 2HP would be very rare.

230V Chart Below

8.0 = 1 HP

10.0 = 2 HP

12.0 = 3 HP

14.0 = 4 HP

16.0 = 5 HP

NOTE: Your pump or motor may say a different Horse Power than what you see here, DO NOT go by what is listed on the motor, go by the amperage on the label.

NOTE for the NOTE: TRUST ME ON THIS, everybody lies about their Horse Power. But the amperage does not lie. Most people are told incorrectly that they have 5 HP pumps.

If you do the math two 230V 5 HP pumps at 16 amps is: 32 amps. Plus a 5.5 KW heater is: + 21 amps.

That means with both pumps running and the heater on it will draw = 53 AMPS.

I bet your HOT TUB is on a 50 AMP breaker…... Therefore contrary to what you have been told you DO NOT have a 5 or 6 or 7 Hp pump.

Impeller Type

	Closed Face
Impeller Diameter OD	4"
Vane Width ID	5/16"
Eye Diameter OD	2-1/8"
Eye Length	11/16"
Impeller Width OD	9/16"
Seal Seat Depth	1/8"
Shaft Length	1-1/2"
Shaft Diameter OD	5/8"
Seal Seat Diameter OD	1-1/4"
Manufacturer	AquaFlo/Gecko
Pump Application	XP2