Valves All Types Ball, Check, Diverter, etc...

This part is a Clear 50 Rib Buttress 3 1/2" Spa Diverter Cap only.  It measures 3 1/2" Edge to edge and the thread width is about 2 3/4" wide.. This Diverter Cap mounts on top of the Diverter Valve with the Stem sticking through then a...

This part is a Clear 18 Rib Orion 3 5/8" Spa Diverter Cap only.  This cap is thicker at 13/16" Thick and most caps are 23/32" thick.. It measures 3 5/8" Edge to edge and the thread width is about 2 3/4" wide.. This Diverter Cap mounts on top...

This part is a Gray Textured 3 3/4" Spa Diverter Cap only.  This is a NON  Buttress Cap if your cap has the word Buttress stamped in it look in our store for a Buttress cap. This Diverter Cap mounts on top of the...

This part is a Gray Smooth 5 Scallop 3 3/4" Spa Diverter Cap only.  This is a NON  Buttress Cap if your cap has the word Buttress stamped in it look in our store for a Buttress cap. This Diverter Cap mounts on top of the...

This part is a Drain Valve with 3/4 inch Barb that is found on some Jacuzzi or Sundance Hot Tubs.. This valve features a hole size of 1 5/16", Receives clear vinyl tubing on one end with the 3/4" barb and a garden hose fitting on the other end....

This part is a Waterway Brand Drain Valve with a Pull Handle for a On/Off Valve, Water Hose Cap... This valve features a 3/4" Slip flex pipe connection.. The pipe that glues into this would measure 1" OD.. FEATURES: Low profile design Hose bib...

Red Epoxy is a new high performance, two-part, heat cured, epoxy repair kit for making permanent repairs on all metals and rigid plastics. Red Epoxy is specifically designed to exhibit a distinct color change when heat cured. Red Epoxy will provide a...

This part is a Drain Cap with a Pull Handle for a Waterway Brand On/Off Valve, Water Hose Cap... Note: Colors can vary Black, White or Green NOTE: This Cap will only work on Waterway Brand Drains do not order for any other brand.. I put an example of...

This part is a Hoss 2" Slip X 2" Slip Slice Gate Valve with Keeper. The Valve recieves a 2" pipe or fitting (Which is about 2 3/8" Inside Diameter) on both sides. This part is used in hot tubs to stop the water so you could service the heater or the...

This part is an Air Check Valve with a 1" Slip Fittings on one end. This valve is used above the water line to allow constant air flow in one direct and to stop water flow in the other direction when plumbed properly in a Hot Tub. This type Check...

This part is a Stem Washer for a Gate Valve on 2003 and under Sundance® Hot Tub Diverter. This Diverter Stem washer Slides onto the Diverter top under the cap.   Click this link for other Sundance Diverter Parts: Sundance® Diverter...

This part is a LA Spa Gray Odd Shaped Diverter Handle 5 1/2" x 2 1/8".