Topside Controls (Control Buttons)

This part is a Artesian Resort Series Overlay for a 7 Button Balboa Topside for 3 Pumps, and a Light.  The Button consist of  Jet 1, Jet 2, Jet 3, Light, Mode, Warm and Cool. This overlay has round ends and is 9 1/2"Long and 2...

This part is a Four Button Overlay Only that fits a VL 400 Topside only.. The button order on this one is a Light, Temp, Jet, Jet.. This overlay works for VS513Z, GS513Z and GS515Z systems.   Topside...

This part is a Three Button Overlay Only that fits a VL 400 Topside only.. The button order on this one is a Light, Temp, Jet.. This overlay works for VS513Z, GS513Z and GS515Z systems.   Topside...

This part is an Overlay Only that fits a VL 400 Topside only.. The button order on this one is a Light, Temp, Jet, Aux.. This overlay works for VS513Z, GS513Z and GS515Z systems.   Topside...

This part is an Overlay that fits some Dreammaker Hot Tubs, E4 Oval, Warm, Cool, Jets, Light.. This overlay is found on some Dreammaker hot tubs but meaure yours to be sure it is the correct size.. Manufacturer  ...

This part is a Overlay, K-52, Sspa-Mp, Two Pump, Bahama Logo for Dynasty Brand Hot Tubs.. If you need the control panel for this overlay click here: Topside Control, K-52, Curved, Pack, No Overlay, 11010

This part is a Circuit Board Kit, Expander for Balboa VS or EL Systems, Blower, w/10 Amp Fuse, w/Cables.. Circuit Board Application Balboa Water Group Circuit Board Model X-P Circuit Board Type New     Circuit...

This part is a Balboa Heater M7 Sensor with a 82" wire found in some HydroQuip Systems using Balboa Boards.  Sensor Application    Spa ControlSensor Type    Hi Limit, Temp or Hi Limit,...

This part is a Balboa Heater M7 Sensor with a 46" wire found in some HydroQuip Systems using Balboa Boards.  Sensor Application    Spa ControlSensor Type    Hi Limit, Temp or Hi Limit,...

This kit is a (1) Standard Balboa Board Replacement Repair Relay along with (1) Spade to Spade Jumper and (1) Spead to Loop Jumper used to do a beef up Jumper Style repair on Some Balboa VS and EL Boards and others...  When replacing board relays...

This tool can be used to drill out the hole in the boards when changing out relays.. After you desolder a relay you can use these bits to open the holes up then slide the new relay in the holes and solder.. This also helps you to prevent damage to the...

This kit is a Set of (2) Standard Balboa Board Replacement Repair Relays along with (3) Spade to Spade Jumpers used to do a beef up Jumper Style repair on Some Balboa BP Boards and others...  When replacing board relays you may need this drill bit...