Sta-Rite Impellers & Parts

This video is about The Spa Guy showing How To Repair a Sta-Rite Dura-Jet Pump that either slow starts or Hums on Low Speed but will run on hgih and then on low after being on high but will not run on low from a dead start... it is a similar process on...

This video is about The Spa Guy showing How To Replace a Sta-Rite Dura-Jet Pump 201 seal and face o-ring... it is a similar process on all brands... Save

You are buying a Kit that features (1) PS-201 Seal and (1) Bearing that fit most motors that are mated to Vico, Sta-Rite, Dura-Jet and Power Right Pump Wet Ends and The Professor's Silly Juice to seal the seal. This Seal is used in Most Vico,...

This part is a set of (2) 2" Pump Union Split Nut Repair Kits which includes the split nut, (2) Screws and a T Gasket for use with a 2" Pump Union. The Pump Union Split Nut that measures about 3" on the Inside of the threaded side and mounts to...

This part is a 2" Pump Union Split Nut Repair Kit which includes the split nut, (2) Screws and a T Gasket for use with a 2" Pump Union. The Pump Union Split Nut that measures about 3" on the Inside of the threaded part and mounts to the...

This part is a Set of (2) 2" Pump Union Split Nut Repair Kit which includes the split nut and (2) Screws for use with a 2" Pump Union. The Pump Union Split Nut that measures about 3" on the Inside of the Threaded Part and mounts to the existing Pump...

This Seal is a (BEST) Silicon Carbide Salt Resistant Upgraded Version of a PS-201 Seal used Primarily in Vico, Sta-Rite and Power Right Wetends. Silicon Carbide’s exceptional wear and chemical resistance, enhanced dry running capability and high...

This part is an Impeller for a Sta-Rite DuraJet DJ Wet End that would be called 1.0hp-1.5HP, your motor should be 8.0-9.0Amp at 230V or 16.0 Amps at 115V.. The number on the back of the impeller will be 17400-0021 or 17400-0121 if you have a number on...

This part is a 2HP Sta-Rite DJ Dura-Jet Pump Impeller.. This impeller will usually have the number 17400-0122 cast into the back and will measure about 3 3/4" wide with an eye width of 1 1 3/4" and a vane width of 1/2".. This can be found on motors with...

This part is a 2.5HP Sta-Rite DJ Dura-Jet Pump Impeller.. This impeller will usually have the number 17400-0123 cast into the back and will measure about 3 3/4" wide with an eye width of 1 3/4" and a vane width of 1/2".. This can be found on motors with...

U.S. SEALUBE is a water based formula specifically designed to lubricate rubber, making the installation of mechanical seals fast and easy. U.S. SEALUBE maintains its wetness for a short period of time. Unlike PTFE or silicone based lubricants which...

This Seal Kit PS-3868 Seal is an Upgraded Better Viton Carbon Graphite Version of the PS-201 Seal used Primarily in Vico & Sta-Rite Wetends.It is 1 3/8" Across the back of the Spring Seal part that goes onto the Impeller and the Ceramic & Rubber...