Spa Hot Tub Pump Seal & (2) Bearing Kit for 2.5HP Pump that fits Intertek 2009+ Jacuzzi® Premium or Sundance® Video How To

This Seal & (2) Bearing Kit fits a 2.5 Horse Power Pump that fits 56 Frame Pump Wet Ends manufactured by Intertek LX Brand and are found on Jacuzzi® Premium or Sundance® brand Hot Tubs only. The pumps this impeller fits usually have the part number 6500-352, 6500-365, 6500-367, 6500-845, 6500-357 or 6500-363 on the label.

Note: Sometimes you have the WUA400-II style part numbers on the pump but if it is a Jacuzzi or Sundance most likely this is the correct Seal.. Another way you can tell which style you have is the spring part of the seal is on the back of the impeller on this style and the spring part is on the volute "back" of the other style... If you have the other style look for "Guangdong LX pump" in our store..

Watch the video for instruction on how to install this part and also how to determine if this is the correct part.

Pump Seal Assy 5/8"Shaft, 1.218"Seal O.D., 1.250"Seal O.D. The Spring Seal part goes onto the shaft of the Impeller and the Ceramic & Rubber part that goes into the Volute. The Hole in both parts is about 5/8". To Install you should put silicon sealant on the shaft of the Impeller and gently push it onto shaft after you have put a small amount of The Professors Silly Juice on the Impeller Shaft. Also the rubber part can use a light coat of silicon to slide it into place in the Volute or Wet End Body. We offer these alone, with The Professor's Silly Juice (Special Hot Tub Silicon Sealer) or with an Impeller in a kit. So if you need an impeller look for the Jacuzzi Premium 2.5HP Impeller Kit. There is only one choice for a seal for this Jacuzzi Premium and Sundance 5/2009+ pump... 

NOTE: This Wet End looks a lot like an Aqua-Flo, Guangdong LX and a CMP Wet End but they do not interchange see the video for how to tell the difference! 

Save

Save

Save

Save

Save

Save

Save

Save