Shaft Seal, PS-201, 3/4" Shaft, Buna Fits Most Vico, Sta-Rite and Power Right Spa Pumps

This Seal is a PS-201 Seal used Primarily in Vico & Sta-Rite Wet Ends..  It is 1 3/8" Across the back of the Spring Seal part that goes onto the Impeller and the Ceramic & Rubber part that goes into the Volute or Wet End Back is 1 3/8". The Hole in both parts is about 3/4". The Spring Seal part goes onto the shaft of the Impeller and the Ceramic & Rubber part that goes into the Volute. The Hole in both parts is about 3/4". To Install you should put silicon sealant on the shaft of the Impeller and gently push it onto shaft after you have put a small amount of silicon on the Impellor Shaft. Also the rubber part can use a light coat of silicon to slide it into place in the Volute or Wet End Body. This Seal fits Sta-Rite and Vico Pumps and Most Cal Spa Pumps including Power Right Please note: When you have a seal leaking in most cases you will need an impeller because the leak caused water to get into the metal shaft area that the impeller is screwed onto and expands and damages the impeller.

For Other Kits with this seal Click the below Links: 

201 Seal Pump Parts Kit with Silicon Fits Most Vico Sta-Rite Spa Hot Tub Pumps

1 Front Bearing & Seal Pump Parts Kit Fits Most Vico Sta-Rite Spa Hot Tub Pumps

Pump Seal PS-3868 Viton Like a PS-201 (Better) Fits Most Vico, Sta-Rite and Power Right Spa Pumps

Shaft Seal, PS-1902, 3/4" Shaft, Silicon Carbide PS-201 (BEST) Fits Most Vico, Sta-Rite and Power Right Spa Pumps