Wet End Pump Parts

This part is a Pump Face for a Vico Ultima Side Discharge wet end that is 2" which measures about 3" edge to edge across the threads.. The Seal Kits for this pump can be found here: Vico Seals 201 The other parts for this pump can be found here: Ultima...

This part is a Wear Ring that measures 2 5/8" inside Diameter and fits some Aqua-Flo XP2e and Xp3 Impellers except the 3.0HP Xp2e Impeller... That Impeller requires a different Wear Ring which measures 2 3/8" Inside Diameter.. Look at the chart in the...

This part is a Gasket for an AquaFlo A, Volute, 4-13/16"ID, 5-1/2"OD, Generic.. Part Type Gasket Inside Diameter 4-13/16"id Outside Diameter 5-1/2"od

This part is a replacement wear ring found in 48 frame 1 1/2" Flo-Master "FMHP" Series Side Discharge and "FMCP" Center Discharge Spa Pumps.. The ring measures about 1 3/4" inside the wear ring and 2 3/16" at the widest part and about 3/4" tall....

This Wear Ring only fits Waterway Executive 1, 2, or 3HP Impellers for a 48 or 56 Frame Pump Wet Ends and measures 1-1/16" thick from front to back... If you have a Waterway Executive 4 or 5 Horsepower Wet End it will require a different wear ring that...

This part is a Wear Ring for a Hi-Flo Impeller found in Waterway Hi-Flo pumps only.. The Inside Diameter of the wear ring is 1 13/16"...

This part is a face plate drain plug for Aqua-Flo pumps.. It does not come with an O-Ring you will find the link to that below.. Aqua-Flo Pump, Drain Plug, O-Ring Xp2, Xp2e, XP3, 7/16" ID, 3/32"  

 This part is the slinger found between the impeller and wet end and the shaft going into the pump motor bearing area and is designed to sling water away from the bearing in case of a seal leak at the wet end.. Note: It has to be placed on the motor...

This Drain Plug fits Vico Ultima and Ultimax and comes without O-Ring.. If you need the O-Ring click the Link: Pump, Drain Plug, O-Ring, will fit most Drain Plugs