Aqua-Flo Wet Ends Complete

This Kit is a 3/8" Tubing Connection Kit for 3/8" Plumbing repairs where you are connecting old 3/8" Clear Tubing that measures about 1/2" OD between a cut air control line and the 3/8" Barb on an Air Manifold or Jet Body Air connection.. The kit...

This is a 1/15th HP Impeller for an Aqua-Flo Circulation Pump 48 Frame Side or Center Discharge CMHP, CMCP and FMVP Series Wet End. This Impeller fits between the Face and the Volute of an Aqua-Flo CMHP, CMCP and FMVP Series Wet End. I would advise...

This Part is (1) NON-Standard 2" Heater or Pump Union Gasket with a 2 5/8" Center to Center Lip. The gasket is 2 7/8" across on the outside the inside diameter is about 2" and the lip that fits into the union is 2 5/8"...

This Face Plate O-Ring Is 5 1/8" Inside Diameter and is 1/8" Thick. It is found on Aqua-Flo 1 1/2" x 1 1/2" (Which Measures 2 3/8" Outside of the threads on the Sunction and Pressure Side of the Wet End) These Wet Ends used the names Flo-Master,...

This is a .5HP or 1/2HP Impeller for an Aqua-Flo 48 Frame Side or Center Discharge FMHP, FMCP, FMVP, and TMCP Series Wet End .5HP Motor that has about 6.0 Amps on High Speed at 230V and 6-7.0 Amps at 115V. This Impeller fits between the Face and the...

This part is a Air Bleeder barbed plug usually used on a Aqua-Flo and CMP Hot Tub Pump Faces to bleed the air off the pump while filling the tub up. I have seen these fittings in many brands of Hot Tubs just compare the pictures and measurements with...

This kit is a Air Bleeder barbed plug and Silicon sealer usually used on a Aqua-Flo and CMP Hot Tub Pump Faces to bleed the air off the pump while filling the tub up. I have seen these fittings in many brands of Hot Tubs just compare the pictures and...

You are buying a 2 1/2" Slip X 2 1/2" Threaded Pump Union with Gasket or O-ring that matches Union. The Union receives a 2 1/2" pipe or fitting on one side which measures about 3" O.D. and then Screws to a 2...

You are buying a 2" Slip X 2 1/2" Threaded Pump Union with Gasket or O-ring that matches Union. The Union recieves a 2" pipe or fitting on one side which measures about 2 3/8" O.D. and then Screws to a 2...

This video is about The Spa Guy showing You How To Remove a Stuck Pump Impeller...This technique is similar for all brands of pumps and motors... Save Save Save Save Save Save Save Save Save Save Save

This video is about The Spa Guy showing You How To Replace a 200 style seal on an Aqua-Flo Pump and put the wet end back together... Save Save Save Save Save Save Save Save Save

This video is about The Spa Guy showing You How To Replace Bearings on an Aqua-Flo Pump.. Bearing replacement is similar for all motors.. Save Save Save Save Save Save Save