Complete Wet Ends

Waterway Hi-Flo Wet EndSide discharge, 2"mbt suction/discharge, 48 frame wet end for the Waterway Hi-Flo pump. This wet end is used with a 11.0 Amp 2.0hp, 48 frame, thru-bolt style motor. The motor used may be either a single or dual speed. The wet end...

This Wet End is a 2" x 2" 1.5HP 48 or 56 frame Ultimax Vico® that would normally be found an a 230V pump with 9.0 Amps High speed or 14.0 Amps at 115v..  This side discharge, 2" x 2" mbt which would measure about 3" edge to edge on the threads,...

NOTE: This Part will Fit Sundance® or Jacuzzi® Tubs with a Guangdong LX Wet End if you replace the entire Wet End for internal parts of the wet end you already have click here Jacuzzi® & Sundance® LX...

  This part is a SWIM56-15 5 Horse Power 56 Frame Pump Bleeder with Silicone & Wet End fits Power-Rite Guangdong LX Brand SWIM56-15 Pump Motors only. These pumps usually have the part number Swim56-15 on the label. Watch the video...

For the bleeder barb for this wet end Click Here: Barbed Bleeder Plug for Guangdong LX 48 Frame Wet End Fine Threads Jacuzzi® or Sundance This part is aSWIM56-15 5 Horse Power 56 Frame Pump Wet End fits Power-Rite Guangdong LX Brand SWIM56-15...

NOTE: There are 48 and 56 Frame verison of these wet ends so be sure you check yours before ordering.. The difference is the position of the thru bolts of the motor and the size of the motor it mounts to.. The 48 Frame version measures 3 5/8" in a...

NOTE: There are 48 and 56 Frame verison of these wet ends so be sure you check yours before ordering.. The difference is the position of the thru bolts of the motor and the size of the motor it mounts to.. The 48 Frame version measures 3 5/8" in a...

NOTE: There are 48 and 56 Frame verison of these wet ends so be sure you check yours before ordering.. The difference is the position of the thru bolts of the motor and the size of the motor it mounts to.. The 48 Frame version measures 3 5/8" in a...

Waterway Hi-Flo Wet EndSide discharge, 2"mbt suction/discharge, 48 frame wet end for the Waterway Hi-Flo pump. This wet end is used with a 12.0 Amp 3.0hp, 48 frame, thru-bolt style motor. The motor used may be either a single or dual speed. The wet end...

This part is a 5 HP 56 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and Wear Ring.  The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will...

You are buying a 4 HP 56 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face, Wear Ring, Bleeder Barb and Silicon.  The Bleeder Barb Replaces one of the plugs and is used to reconnect your previous...

You are buying a 3 HP 56 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face, Wear Ring, Bleeder Barb and Silicon.              The Bleeder Barb Replaces one of the...