Pump, Circulation, Gecko AquaFlo CMCP, 1/15hp, 230v, 1-1/2", Center Discharge
- SKU:
- HTP34-402-BB46
- Shipping:
- Calculated at Checkout
Description
This is a 230V Center Discharge Aqua-Flo Circulation pump with a 1 1/2" Suction and Pressure side that measures about 2 3/8" Across the threads.
Circ-Master pump takes 24-hour filtration to a new level, delivering the highest GPM of any recirculation pump on the spa industry. Higher GPM allows the Circ-Master to operate a high-flow heating system resulting in increased heating efficiency and up to four times the filtration.
Spa Pump Features:
- 48 frame, continuous-duty construction with front and rear, permanently lubricated ball bearings for extended motor life.
- Carbon-graphite self-lubricating seal designed for continuous duty operation.
- 1-1/2" suction and discharge.
- Quick release compression fittings allow for easy installation or maintenance.
- Available in side discharge and center discharge models.
- Available with 115v and 230v motors.
This pump uses an impeller rated at 0.75ohp. When installed on a motor that turns at 1725RPM, the pump becomes 1/15th horsepower.
| Complete Pump Type | Circulation Pump |
| Speed | 1 Speed (1-Spd) |
| Motor Voltage | 230v |
| Drain Plug Location | 3,6,9 o`clock |
| Pump to Motor Foot Types | 15 |
| Suction Style | Center |
| Suction Connection (Physical Dimension) | 1-7/8" id, 2-7/16" od |
| Suction Connection Type | Female Pipe Thread (fpt), Male Buttress Thread (mbt) |
| Suction Pipe Size | 1-1/2" |
| Discharge Style | Center |
| Discharge Connection (Physical Dimension) | 2-7/16" od |
| Discharge Connection Type | Male Buttress Thread (mbt) |
| Discharge Pipe Size | 1-1/2" |
| Horsepower | 1/15hp |
| Motor Frame | 48 Frame Thru-Bolt |
| Motor Amperage/Wattage | 0.6A |
| Manufacturer | AquaFlo/Gecko |
| Pump Model | Circ-Master CMHP |
| Volute Fastening Type | 8 Screws |
02593000-2010
IMPORTANT MOTOR VARIATION NOTICE
Due to ongoing changes in the hot tub pump industry since COVID, motor appearance and configuration may vary, even when the part number is the same. While the pump wet end will be correct, the motor may differ in areas such as capacitor location, labeling, or housing.
If you have a specific motor requirement (clearance, capacitor position, orientation, etc.), you must contact us before ordering so we can verify availability. Do not order first and contact us after delivery due to appearance differences.
Motor variations are outside of our control and may change week to week. Appearance differences do not constitute an incorrect item if specifications are met.