Pressure Switch, 4010P, 25A, Tecmark, 1/8"mpt, SPNO, Plastic

"You are buying a Techmark 4000 Series 25Amp Pressure Switch with a Plastic Bottom and top that features 1/8th"" MPT Standard Threads and 2 Spade connectors for attaching the 2 wire connections. This Switch will fit Balboa, Gecko, ACC, Hydroquip, Len Gordon, Maddux and most other standard Hot Tub Heater Tubes but the 25Amp feature is rarely found. The 25Amp switch would normally be found in a 115V Plugged in stsyle where the hot wire for the Heater runs through the switch.

What goes wrong with these switches is either the Switch does not close when the pump comes on and puts pressure on the switch or it doesn't open when the pump goes off. If either of these things happens you will have a No Heat or Overheat Situation on most systems. The are other things that will cause a flo code like an inoperative pump or a stopped up filter so be sure the switch is bad before replacing.