XP2 1.5 HP Impeller Aqua-Flo 2 1/8" Eye with 5/16" Vane Width 4" OD 230/9A or 115/14A
- SKU:
- HTP35-402-1410/916941KE
- Shipping:
- Calculated at Checkout
Description
This is a 1.5HP Impeller with a 2 1/8" Eye Width and a 5/16" Vane Width and 4" OD for an Aqua-Flo 48 or 56 Frame Wet End 1.5HP Motor that has about 9.0 Amps at 230V. This Impeller fits between the Face and the Volute of an Aqua-Flo XP2 or FMXP2 Wet End. I would advise replacing the Seal when you replace the Impeller. This Impeller uses a PS-200 Seal that can be found in our store. Choose with care, I Do Not accept returns so be sure these are correct before ordering! Visit our Store as we also offer these and other associated products and accessories for your Spa. Note: A 115v motor that uses a 1 HP Impeller would show about 11-12.0 Amps on high speed a 230V motor would show about 8.0 Amps on High. See chart below for other Horsepowers. Do Not choose a Larger Impeller thinking that it will make your Hot Tub Stronger it will only damage the Motor and make it run hot on high speed. To determine the HP refer to the chart below.. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will be 3 5/8" between or 5 3/16" in a X Pattern with a 1/4" Bolt Head and the 56 Frame will be 4 1/8" Between or 5 3/4" in a X Pattern with a 5/16" Bolt Head. 91694150
This Impeller uses a PS-200 Seal that can be found Click Here.
Note: A 115v motor that uses a 1.5 HP Impeller would show about 14.0 Amps on high speed a 230V motor would show about 9.0 Amps on High. See chart below for other Horsepowers.
Do Not choose a Larger Impeller thinking that it will make your Hot Tub Stronger it will only damage the Motor and make it run hot on high speed as well as there are (3) different size wear rings on the impellers so if you choose a different size impeller your wear ring may not work. Measure your wear ring to determine which impeller section you should be in.. 2 1/8", 2 3/8" or 2 5/8" look for the eye sizes in the impeller description area...
I bet your HOT TUB is on a 50 AMP breaker…... Therefore contrary to what you have been told you DO NOT have a 5 or 6 or 7 Hp pump.
Impeller Type
Closed Face | |
Impeller Diameter OD | 4" |
Vane Width ID | 5/16" |
Eye Diameter OD | 2-1/8" |
Eye Length | 11/16" |
Impeller Width OD | 9/16" |
Seal Seat Depth | 1/8" |
Shaft Length | 1-1/2" |
Shaft Diameter OD | 5/8" |
Seal Seat Diameter OD | 1-1/4" |
Manufacturer | AquaFlo/Gecko |
Pump Application | XP2 |