Master Spa and Down East Hot Tub Parts

  Filter, Cartridge, 30sqft, 1-1/4" Female SAE Thread, 4-3/4" Wide, 11-3/8" Tall Note: The 1 1/4" Thread is a very usual size are sure you are correct before ordering..   These are found on some Saratoga Hot Tubs.  Bottom Physical...

This part is a complete Heater, Flo Thru, Balboa M7, 800, 825, 15" x 2", 230v or 115v , 4.0kW, with Sensors..  This heater tube has a stud on the top and bottom make sure yours has them too.. This heater DOES include m7 sensors and split nuts,...

This part is a Balboa Replacement Circuit board for an MS5000 Mach 3 system it is a new board and can be found under several different numbers.. The compatible topside would be a MOLEX system plug not a phone plug. New models will come with the...

This part is a Magic Plastics Drain Valve that mounts through the side wall with a removable front nut to release it from the side panel.. It features a 3/4" Barb and measures about 7" Long overall.. If you need the smaller version of this valve it can...

This part is a Balboa Circuit board replacement for a Master Spa 54418 EL8000 Mach 3 system it is a new board and can be found under several different numbers..If you have a TV in your model do not order this board as the replacement doesn't have support...

This part is a Ozone Flash Reactor Replacement with a  3/4" Barb X 3/4" Barb connection.. It is used as a Mixing Chamber Mazzei on Ozone systems for Jacuzzi, Sundance, Master Spa and others..

Balboa Water GroupStainless steel replacement heater assembly, 5.5kW/230v, 2" x 15". Includes a pressure switch, Hi Limit Sensor on the right side. Made for Balboa Value and Balboa LE control systems. Housing Configuration  ...

This part is a 8" Master Spa Twilight Series DSG Jet. This Jet is 8" across the Face it depends on how you measure it. It features 14 black nozzles and chrome. Adjustable Master Massage Jet Assembly with L Gasket DSG Stainless Steel...   This...

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Pressure Switch Cable that is 7" long and Universal for use on most SSPA, MSPA, T-MSPA, and some Hydroquip boards..

This part is a Master Spa 8 Button Overlay for Master Spa Legend Series 2005-2012 Topside for a Three Pumps with Light. This Overlay can be used to replace your original Overlay with your brand on it as long as the button configuration works out...