HotSpring, Watkins, Caldera, Tiger River Spa Parts

This Seal Kit is used ONLY in Watkins Hot Spring Caldera Wet Ends where the motor has the Vendor code of 3536. This kit features the seal and an install tool as well as silicone to install the seal with.. It is 1 39/64" Across the back of the Spring...

This Seal Set is used ONLY in Watkins HotSpring Caldera Wet Ends where the motor has the Vendor code of 3536. It is 1 39/64" Across the back of the Spring Seal part that goes into the volute or wetend back and the Ceramic & Rubber part that goes...

This Kit Fits Watkins, Vendor #4081, Wavemaster Pumps found under the name Wavemaster. This Kit Features (2) Bearings, (1) Seal and (1) 1/2oz Tube of The Professor's Silly Juice a Specially Formulated for Hot Tubs Silicon Sealer.   Note: Watkins...

This kit Fits Watkins, Vendor #4081, Wavemaster XP2 Pumps found under the name Wavemaster with the Vendor Code 4081 only.. Features (1) Seal for XP2 Pumps on Hotspring Watkins Hot Tubs, Seal Install Tool and (1) 1/2oz Tube of The Professor's Silly Juice...

This 4 way Tee with Glue Kit is exclusively for HotSpring Hot Tubs made by Watkins and can be found under the name Hotspring, Solana, Tiger River, Caldera...  This is Kit consists of a 1" x 1" X 1" Tee with (2) barbed 1" Slip X 3/8" Barb Fittings...

This 4 way Tee Kit is exclusively for HotSpring Hot Tubs made by Watkins and can be found under the name Hotspring, Solana, Tiger River, Caldera...  This is Kit consists of a 1" x 1" X 1" Tee with (2) barbed 1" Slip X 3/8" Barb Fittings that glue...

This Parts is a NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2" center to center... Do not buy this O-Ring until you...

This part is a Replacement Watkins Water Check Valve that is 3/4"Barb x 3/4" Barb..   This 3/4" water check valve is installed in the inlet side of the circulation pumps plumbing to prevent the back flow of water through the circulation pump once...

This is a Watkins Wavemaster 9000 or 9200 2.5HP Seal Kit & Impeller with a 2 1/8" Eye Width. This Impeller fits between the Face and the Volute of a XP2 Wet End found on some Watkins Hot Spring Caldera pumps with Vendor Code 4081...

This part is an Barb Replacement Kit for Watkins, Hotspring, Tiger River, No Fault Heaters.  Make sure heater looks like these it does not fit all heaters..  Below is a list of related parts click on the links for each...

This part is an O-Ring Replacement Kit for Watkins, Hotspring, Tiger River, No Fault Heaters.  Make sure heater looks like these it does not fit all heaters..  Below is a list of related parts click on the links for...

This part is an Adapter Kit to convert the new style sensor set for Watkins No-Fault 4000 or 6000 heaters to the old style plugs.. Includes: The Two Adapters only for the Sensors click the link below: Below is a list of related parts click on the links...