Hot Tub Parts by Tub Brand

This part is a Cartridge Filter 8" x 7" Wide 2" male pipe thread  32sqft found in some Artesian, Coleman or Maax Hot Tubs. This filter is 8" long x 7 " Wide. This filter has a threaded nipple that would measure about 2 3/8"...

This part is a Pump Bleeder Barb for some Watkins Wavemaster LX Pumps and others.. It is 1/2" Barb x 1/4"Mpt and is used with an unusually large bleeder line.. The line is 1/2" Inside Diameter not 3/8" Inside Diameter like most bleeder lines.. This...

This Seal Kit for 6500-907 LX CIRCULATION PUMP 230V 2006+ JACUZZI® J-400 PREMIUM SUNDANCE® Pumps Only. It is 1 39/64" Across the back of the Spring Seal part that goes into the volute or wetend back and the Ceramic & Rubber part that...

This part is a 3 1/4" JACUZZI® Premium Gray Mini Powerp Dx (Rotational) Jet.    Jet Part Type Internal Face Diameter 3-1/4" Manufacturer Jacuzzi Model Mini PowerPro...

This Part is a 48 or 56 Frame Face Plate for a Jacuzzi or Sundance Intertek LX Brand Pump Wet End only this face plate uses fine thread bleeder plugs be sure to compare your old plugs to the pictures. This face has a flange inside...

This Kit is an Upgraded 3 3/4" Wide Buttress Silver Diverter Valve Cap, Valve Stem with a Swoosh Black Knob and O-Ring Kit. This Kit comes with The Swoosh Handle, Valve Stem, Buttress Cap and (2) Small O-Rings and (1) Large O-Ring...

This Kit is an Upgraded  3 3/4" Wide Buttress Diverter Valve Cap with a Black Knob and O-Ring Kit. This Kit comes with The Teardrop Handle, Buttress Cap and (2) Small O-Rings and (1) Large O-Ring. The Valve these parts fit is found on...

This part is a Balboa 6 Button Overlay for a VL620S or VL600 Topside with Two Pumps and Light System. On the overlay starting at the left of the readout it reads Jets, Aux, Light and to the right is Warm, Mode, Cool. This Overlay has an Adhesive back you...

This part is a Balboa 6 Button Overlay for a Topside for a Pump and Blower with Light System. On the overlay starting at the left of the readout it reads Jets, Blower, Light and Warm, Mode, Cool. This Overlay has an Adhesive back you simply clean the old...

This Kit is a Silicone Kit & Lo-Profile Drain Assembly, 3/4" slip or 1" Street, Gray, 1-15/16" Face Width Replacement Bottom Drain Fitting Kit found on many brands of Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one...

This part is a South Seas Spas Overlay for a 7 Button Balboa Topside for 3 Pumps, and a Light.  The Button consist of  Jet 1, Jet 2, Jet 3, Light, Mode, Warm and Cool. This overlay has round ends and is 9 1/2"Long and 2 5/8"wide. The...

NOTE: This Overlay is Obsolete but we do have a generic Balboa Version we will ship you in place of this one that will work. See the second picture. This part is a Artesian Resort Series Overlay for a 7 Button Balboa Topside for 3 Pumps,...