Hot Tub Parts by Tub Brand

This Part is a 48 or 56 Frame Face Plate for a Jacuzzi or Sundance Intertek LX Brand Pump Wet End only this face plate uses fine thread bleeder plugs be sure to compare your old plugs to the pictures. This face has a flange inside...

This Kit is an Upgraded 3 3/4" Wide Buttress Silver Diverter Valve Cap, Valve Stem with a Swoosh Black Knob and O-Ring Kit. This Kit comes with The Swoosh Handle, Valve Stem, Buttress Cap and (2) Small O-Rings and (1) Large O-Ring...

This Kit is an Upgraded  3 3/4" Wide Buttress Diverter Valve Cap with a Black Knob and O-Ring Kit. This Kit comes with The Teardrop Handle, Buttress Cap and (2) Small O-Rings and (1) Large O-Ring. The Valve these parts fit is found on...

This part is a Balboa 6 Button Overlay for a VL620S or VL600 Topside with Two Pumps and Light System. On the overlay starting at the left of the readout it reads Jets, Aux, Light and to the right is Warm, Mode, Cool. This Overlay has an Adhesive back you...

This part is a Balboa 6 Button Overlay for a Topside for a Pump and Blower with Light System. On the overlay starting at the left of the readout it reads Jets, Blower, Light and Warm, Mode, Cool. This Overlay has an Adhesive back you simply clean the old...

This Kit is a Silicone Kit & Lo-Profile Drain Assembly, 3/4" slip or 1" Street, Gray, 1-15/16" Face Width Replacement Bottom Drain Fitting Kit found on many brands of Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one...

This part is a South Seas Spas Overlay for a 7 Button Balboa Topside for 3 Pumps, and a Light.  The Button consist of  Jet 1, Jet 2, Jet 3, Light, Mode, Warm and Cool. This overlay has round ends and is 9 1/2"Long and 2 5/8"wide. The...

This part is a Artesian Resort Series Overlay for a 7 Button Balboa Topside for 3 Pumps, and a Light.  The Button consist of  Jet 1, Jet 2, Jet 3, Light, Mode, Warm and Cool. This overlay has round ends and is 9 1/2"Long and 2...

This New Old Stock part is a Complete Hot Tub Spa Part Clear 7 5/8" Waterfall Assembly 2 Hole Style Hole size is about 1" each.. You will get (2) 90 degree 1/2' Slip fittings with the waterfall.. If you need this waterfall to be barbed you will need 2...

This part is an Air Check Valve Kit with a 1" Air Check Valve a (4) 3/8" Barb Transistion Manifold with (2) Plugs that can be down to (2) Barbs and a 4oz can of glue to glue it all together. This valve is used above the water line to allow constant...

This part is an Air Check Valve with a 1" Slip Fittings on one end. This valve is used above the water line to allow constant air flow in one direct and to stop water flow in the other direction when plumbed properly in a Hot Tub. This type Check...

This part is a Stem Washer for a Gate Valve on 2003 and under Sundance® Hot Tub Diverter. This Diverter Stem washer Slides onto the Diverter top under the cap.   Click this link for other Sundance Diverter Parts: Sundance® Diverter...