Hot Tub Parts by Tub Brand

This part is aSpa Diverter Valve Internal Stem only. This Diverter fits many different brands but it looks similar to some brands that it will not fit so be careful in your choice, check the measurements against your old stem valve and watch the...

 This filter is 13 1/2" X 4 15/16" and has a female SAE Large Thick Thread that is 2" which would really nmeassure about 2 1/4-2 3/8" ID. This filter is found in Four Winds Tubs, Barefoot and others.  If you have the shorter verison of this...

This filter fits some Hotspring, Tiger River, Watkins Hot tubs.. It is a Filter, Cartridge, 65sqft, 3" Top Hole ID, 3" Bottom Hole ID , 8-1/2" Wide, 10-1/2" Tall.. Application Hot Spring Spas (Watkins), Tiger River Spas (Watkins), Watkins...

This Filter cartridge is 5 5/16" Wide X 10 1/8" Tall.. It has a 2 1/8" hole on the top and bottom... it is 45 Sq Ft and is found in a lot of different brands... Dynasty Spas, Garden Leisure, Leisure Bay, Recreation Warehouse, Rainbow,Pentair,...

This item is a Black Replacement Diverter Cap for a 1" Waterfall or Neck Jet Control.. The inside thread measurement is about 1 5/8" and the center hole is about 3/4".. It uses (2) Small o-rings and one O-Ring Gasket that measures about 1 1/2"...

This filter is found only in Sundance Hot Tubs that is 19" long x 8 1/2" Wide and it has a hole in one end that is 2 1/2" that slips over a fitting with a nut ti tighten it into place and a nipple on the other end that is 2" wide that slips into a...

Standard Pump Union Adapter Assembly With this adapter you can convert a 2" Threaded Pump Union whcih measures about 3" I.D. to a 1 1/2" threaded fitting which = 1 7/8" O.D. standard wet end. An O-Ring does come with this fitting but if you just needed...

This part is a Handle, Waterway Top Access Diverter Valve, 2", Gray, Measures about 4" Long.

This part is an Jacuzzi J Pump Impeller Wear Ring.. It measures about 1 15/16" ID and 2 7/16" to the outermost OD..  Fits the following pumps: Cygnet Series - All Horsepowers J, JCM, K and KM Series - All Horsepowers L, LC, LCUN2,...

This part is a Pump Bleeder Barb with O-Ring that is found on some Aqua-Flo Xp2 and Xp2e wet ends but is used with an unusual bleeder line.. The line is 1/4" Inside Diameter not 3/8" Inside Diameter like most bleeder lines.. This part does come with the...

This part is an O-Ring that is a square style.. It fits Piranha "A", Thera-Flo, Thera-Max, Bracketless, all found on Jacuzzi, Sundance, Hotspring and other brands as well...Part Type    Square RingO Reference Number  ...

This filter is 9 3/4" Tall x 4 5/8" Wide and is closed on the top and has a 1 1/2" mpt thin threaded nipple that measures about 1 13/16" across the threads. This filter fits some of the Jacuzzi Whirlpool hot tubs that are found under the names Jacuzzi...