Hot Tub Parts by Tub Brand

This kit is a Set of (2) Air Bleeder barbed plugs,(2) 3/8" x 3/8" Barb couplers, (2) 4" long pieces of 3/8" Tubing and Silicon sealer usually used on a Dynasty Hot Tub with Waterway Hot Tub Pump Face to bleed the air off the pump while filling the tub up...

This kit is a Set of (2) Air Bleeder barbed plugs and Silicon sealer usually used on a Dynasty Hot Tub with Waterway Hot Tub Pump Face to bleed the air off the pump while filling the tub up. I have seen these fittings in many brands just compare the...

This 4 way Tee with Glue Kit is exclusively for HotSpring Hot Tubs made by Watkins and can be found under the name Hotspring, Solana, Tiger River, Caldera...  This is Kit consists of a 1" x 1" X 1" Tee with (2) barbed 1" Slip X 3/8" Barb Fittings...

This 4 way Tee Kit is exclusively for HotSpring Hot Tubs made by Watkins and can be found under the name Hotspring, Solana, Tiger River, Caldera...  This is Kit consists of a 1" x 1" X 1" Tee with (2) barbed 1" Slip X 3/8" Barb Fittings that glue...

This part is a Black 3 1/4" Long Catalina Spa Diverter Handle Knob only. This Diverter Knob mounts on top of the Diverter Valve Stem Square that is about 7/16" Wide sticking through the diverter cap. The Diverter Valve that this part fits...

This part is a Electronic Pressure Switch for Watkins Solana, Caldera & Hot Spot, 2006 Thru Current that features 1/8th" MPT Standard Threads and 2 pin connectors for attaching the 2 wire 3 hole connector for a Watkins board. What goes...

This Parts is a NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2" center to center... Do not buy this O-Ring until you...

This part is a 3" wide Air Valve Handle in Gray that fits some Dynasty Air Valves.  This Diverter handle Slides on the Air Control Valve Stem that measures about 1/4" and is used to operate the Air Valves and is for Dynasty Spa only. The...

This part is a 3" wide Air Valve Handle in Black that fits some Dynasty Air Valves. This handle Says Trevi instead of Dynasty but they are exactly the same.. Dynasty sent us Trevi instead of Dynasty because they  This Diverter handle...

This part is a Replacement Watkins Water Check Valve that is 3/4"Barb x 3/4" Barb..   This 3/4" water check valve is installed in the inlet side of the circulation pumps plumbing to prevent the back flow of water through the circulation pump once...

This part is an O-Ring that fits a Jacuzzi® J Pump Style Pump Union Only.. This O-Ring measures about 2-3/16" Inside Diameter and about 2 1/2" Outside Diameter.. Make sure you look at the pictures of a J Pump union provided in the picture section...

This part is a Hot Tub Pillow that is 9 1/2" x 4 1/4"  and 6-1/2" between the Tabs it fits a variety of brands some are out of business. It fits some Infinity, Raindance, Serenity, Premier, Serenity, Dimension One and Also Four Winds...