Hot Tub Parts by Tub Brand

This 1" Waterfall Control Plunger and Cap Replacement Kit is found in some 1" Waterfall or Neck Jet Control valves. This kit features the Cap, plunger and stem, The Gasket for the bottom of the plunger and clip that holds the stem inside the cap and an...

This part is a Diverter Kit with a Stem, Silver "S" Style 4 5/16" Long Diverter Handle, Graphite 3 11/16" Graphite Cap & O-ring Kit. This Diverter Knob has a S Shaped Top and mounts on top of the Diverter Valve Stem Square that is...

This part is a Reinforced "S" Style 4 5/16" Gray Spa Diverter Handle Knob only. This Diverter Knob has a S Shaped Top and mounts on top of the Diverter Valve Stem Square that is about 7/16" Wide sticking through the diverter cap. The...

This part is a Silver "S" Style 4 5/16" Long Diverter Handle and Graphite 3 11/16" Graphite Cap & O-ring Kit only. This Diverter Knob has a S Shaped Top and mounts on top of the Diverter Valve Stem Square that is about 7/16" Wide...

This part is a Silver "S" Style 4 5/16" Long Diverter Handle and Graphite 3 11/16" Graphite Cap only. This Diverter Knob has a S Shaped Top and mounts on top of the Diverter Valve Stem Square that is about 7/16" Wide sticking through the...

This part is a "S" Style 4 5/16" Silver Spa Diverter Handle Knob only. This Diverter Knob has a S Shaped Top and mounts on top of the Diverter Valve Stem Square that is about 7/16" Wide sticking through the diverter cap. The Diverter Valve...

This New Old Stock part is a Complete Hot Tub Spa Part Gray 11" Waterfall Assembly 3 Hole Style Graphite Gray Hole size is about 1 3/4" each.. You will get a 90 degree 3/4' Barb with the waterfall.. These Waterfalls are hard to come by but we do have...

This part is a Heater M7 Sensor with a 31" wire found in Jacuzzi Premium J series 2016 to current.  Note: This sensor does not have the nut and washer on it so it will only work with Jacuzzi Premium hot tubs..   Application Balboa...

  Filter, Cartridge, 30sqft, 1-1/4" Female SAE Thread, 4-3/4" Wide, 11-3/8" Tall Note: The 1 1/4" Thread is a very usual size are sure you are correct before ordering..   These are found on some Saratoga Hot Tubs.  Bottom Physical...

This Vendor Code 3536 2.5 Horse Power Impeller, Seal, Silicon & Seal Installation Tool that fits a 56 Frame Pump Wet Ends manufactured by Intertek with numbers 39578-03, 37066-03 or 0982601-03 only.  See NOTES Below... Watch the video...

This part is a Pump Bleeder Barb fit some Watkins Wavemaster LX Pumps and others.. It is 1/2" Barb x 1/4"Mpt and is used with an unusually large bleeder line.. The line is 1/2" Inside Diameter not 3/8" Inside Diameter like most bleeder lines.. This part...

As of 11/2024 Aqua-flo has started to send this pump with a capacitor bump in an odd spot that may affect your installation. In light of that we are now sending this pump assembly out as a separate 10.5 Amp motor and a genuine 2.5 HP XP2 wetend. You...