Hot Tub Parts by Tub Brand

This part is a Ozone Flash Reactor Replacement with a  3/4" Barb X 3/4" Barb connection.. It is used as a Mixing Chamber Mazzei on Ozone systems for Jacuzzi, Sundance, Master Spa and others..

This part is a Base Mounting Bracket, Pump, LX, Sundance, Jacuzzi, 56 Frame found in some Sundance or Jacuzzi Hot Tubs.For the pumps that are used with this bracket click these links: 56Fr Jacuzzi® Sundance Intertek Baseless Pump 2" X 2" 2...

Watkins Vendor Code 4081 Older Style Wavemaster, 4000, 6000, 7000, 8000, 8200, 9000, 9200... 48Frame Pump Face O-Ring Only fits around the Face of this Pump Face... There are (2) Different versions of the Face plate O-Ring on the Xp2 Wet Ends.. The...

This Part is a 2 1/8" wear ring that is used between the impeller and the wet end face on Watkins Vendor Code # 4081, Wavemaster, 4000, 6000, 7000, 8000, 8200, 9000, 9200.. This wear ring serves as a seal between the suction and pressure sides of the...

  This is a 1HP Seal & Impeller Kit for a Watkins 37334 Vendor Code# 4081 Pump with a 2 1/8" Eye with 1/4" Vane Width and 3 7/8" OD for an Wavemaster 48 1.0HP Motor would be about 7-8.0 Amps on high speed at 230V or 11-12.0 Amps at...

This part is a Replacement Watkins Water Check Valve that is 3/4"Barb x 3/4" Barb with Connect kit..  This kit is used to make the connection to existing  3/4" Clear to extend it on either side of the old chekc valve or to attach 1/2" Flex...

This Part is a Wet End O-Ring for a 48 or 56 Frame Face Plate for a Jacuzzi Premium or Sundance WUA400 6500 Intertek LX Brand Pump Wet End only.. Watch the video for instruction on how to install this part and also how to determine if this...

This Parts is a NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2" center to center... Do not buy this O-Ring until you...

This 1" CMP Waterfall Control Plunger Replacement Kit that includes the Cap, Handle, PLunger Assembly and o-rings.. This kit is found in some 1" CMP Waterfall or Neck Jet Control valves.  NOTE: This Plunger looks a lot like the Waterway Brand...

This part is a Gray 3 5/8" Handle Knob for a 4" Wide Sundance® 3 Way Spa Diverter Valve. This Item is the Handle Only. The Valve this parts fits is found on Sundance® Spas only!!  Compare the measurements to be sure this...

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...