Hot Tub Parts by Tub Brand

  This part is a 3 Terminal Power Block found on some Jacuzzi or Sundance Control pack and board set ups..   Jacuzzi® Spa Terminal Block, Two Position Strip (TB1, All Models Except The J-380/J-385, J310/J-315 And J-230). Also...

This filter fits Jacuzzi Premium Hot Tubs J-300, J-400 Series. It is 15 1/2" Tall and 6 5/8" Around and Features a 2" SAE which is a Thick Thread and measures a hair less than 2" Inside diameter and measures 2 3/8" to the outside of the threads. There...

This part is a Magic Plastics Drain Valve that mounts through the side wall with a removable front nut to release it from the side panel.. It features a 3/4" Barb and measures about 7" Long overall.. If you need the smaller version of this valve it can...

This part is a Hot Tub Replacement Bottom Drain Inside Wall Fitting with a 3/4" slip fitting on each end which measures about 1" I.D.. This part is on the foam side of the tub and the Fitting screws into this fitting.. You have to stand the hot tub up...

This 1.5HP Impeller fits a Jacuzzi Piranha 8 Stand Wet End Fixed Bracket Motor only and would be found on a motor that is about 15.6-16.0 Amps on a 115V motor or 7.8-9.0 Amps on a 230V motor..... It can be found under the Name Thera-Max or Thera-Flo on...

This part is a 2.0HP Impeller that fits some Piranha Wet Ends found on Sundance, Jacuzzi and other brand Hot Tubs.. Click Here for Seal and Other Part options for this impeller: (8) Mount Parts     Impeller Type Closed...

This part is a Plastic Cage used inside of a Sundance Microfiber Filter..  For the filters and parts that would be used with this part click these links: Sundance Filter, 80sqft, 2"SAE, 2-1/2" Open Hole, 8-1/2" X 14", Used with Roll...

This Part is a Fine Thread Bleeder Plug for a 48 or 56 Frame Vendor Code 3536 LX Pump Wet End.

This part is a Wear Ring that only fits LX Vendor Code 3536 Impellers for a 48 or 56 Frame Pump Wet Ends and measures 13/16" thick from front to back... LX Pumps..  

This Part is a Wet End O-Ring for a 48 or 56 Frame Face Plate for a Vendor Code 3536 Intertek Brand Pump Wet End only.. It is about 6 3/8"" Inside Diameter and about 1/8" Thick..      ...

This part is an O-Ring that fits a Watkins Wavemaster 7000 Vendor Code 0108 only wet end..   6" ID, 1/8" X Section Square.. The Watkins pump this fits looks like this:  

This part is a Kit that features (2) Seal, (1) Bearing, Seal Tool and Silicon that fit a Watkins, Piranha, Vendor Code 0108, 1.65hp, Wavemaster 7000. To Install you should put silicone sealant on the back of the Metal part and gently push it into place...