Hot Tub Parts by Tub Brand

This Kit features a 2.5 Horse Power Impeller only that fits 56 Frame Pump Wet Ends manufactured by Intertek LX Brand and are found on Jacuzzi® Premium or Sundance® brand Hot Tubs only. The pumps this impeller fits usually have the part...

This Item is an Eco Pur Filter for the Teleweir System on Master Spa Build tubs.. It is 5" Wide X 3 1/2" Tall on the cartridge and has a 1 1/2" SAE Threaded fitting that measure about 1 7/8" Edge to edge on the threads.. This filters works with some but...

This part is a Flow Switch Tee Housing with a Barb, Sundance and Jacuzzi Premium Replacement, 3/4" Barb x 3/4" Barb x 3/8" Barb..

This is an Aqua-Flo 39577 2.0HP Seal Kit & Impeller with a 2 1/8" Eye Width... This Impeller fits between the Face and the Volute of a XP2 Wet End found on some pumps with Vendor Code 4081. Impeller Type   Closed Face Impeller Diameter...

This part is a 5 1/8" JACUZZI® Premium 1" Barb Maxx Power Pro Jet Body that fits some 2002-2005 models..   April 2003 introduced a removable 1” bayonet eyeball, barb style Jet Back 6540-743 above.   We...

This part is a Halo Style Water Control Valve normally used for a Waterfall or Neck Jet Control, it is a full On/Off Valve made by Waterway, the plumbing connects are 3/4" Barb x 3/4" Barb Single Port.. To connect the valve to 3/4" plumbing simply glue...

This part is a Balboa Heater M7 Sensor with a 82" wire found in some HydroQuip Systems using Balboa Boards.  Sensor Application    Spa ControlSensor Type    Hi Limit, Temp or Hi Limit,...

This part is a Balboa Heater M7 Sensor with a 46" wire found in some HydroQuip Systems using Balboa Boards.  Sensor Application    Spa ControlSensor Type    Hi Limit, Temp or Hi Limit,...

This LX 1019801-03 or 39577-03 Vendor Code 3536 2HP Impeller that fits 56 Frame Pump Wet Ends manufactured by Intertek LX Brand only. It is about 4 1/8"" across the face edge to edge, it measures about 3" from the tip of the front to the tip of the...

This part is a Cal Spa Gray 3" Storm Jet Insert Pentair Cyclone Micro.. You remove this jet but twisting the face hard left.. It will push itself out..

This part is a Cal Spa Gray 3 1/2" Jet Insert Maxi Flow Reg Face - 2001 American Products.. You remove this jet but taking a small flat screw driver and sliding the tab found inside the face around the edge out and grabbing the face and sliding the...

This kit is features a 1 Amp Pressure Switch and (2) Blue Spade connectors that can be used in place of the Tradional Square Pressure Switch found on some Hotspring Tubs by Watkins.. This Switch features 1/8th" MPT Standard Threads and 2 Spade...