Heater Assemblies, Low Flow

This video is The Spa Guy teaching you how to Diagnose a New Wire Up Situation where you just wired your hot tub up and it is tripping the breaker and it is either a new tub or it is used and ran fine at the last location...... Save

This part is a 2 1/2" Thread X 1" 90 Degree Barb Heater Union with Gasket that matches Union.   The Union receives a 1" ID pipe on the barb side and then Screws to a 2 1/2'" Heater Flange using a 2 1/2" Nut on the heater side...

Sundance SpasVertical heater assembly 3-1/2" x 13" with 3/4" barb x 3/4" 90° barb inlet/outlets. Rated at 5.5kW/240v. Purchase of a foam wrap jacket is recommended when purchasing manifold

This item is a 1/8" MPT Brass Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole or...

This item is a 1/8" MPT Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole or the...