Control Boards and Systems

This Plumbing & Glue kit is used to change from a Cal Spa Dually Pump setup to a single Pump set up since the dually pump has been discontinued.. You will have to modify the plumbing and note that this kit is for most applications and may not be...

This part is a 3 Terminal Power Block found on some Jacuzzi or Sundance Control pack and board set ups.. This part is found in some Jacuzzi Premium J-220, J-210, J-315, J-310, 2004 J-325, and 2008+ J-325 models and some Sundance 800 or 850 systems....

This part is a Circuit Board Kit, Expander for Balboa VS or EL Systems, Blower, w/10 Amp Fuse, w/Cables.. Circuit Board Application Balboa Water Group Circuit Board Model X-P Circuit Board Type New     Circuit...

This kit is a (1) Standard Balboa Board Replacement Repair Relay along with (1) Spade to Spade Jumper and (1) Spead to Loop Jumper used to do a beef up Jumper Style repair on Some Balboa VS and EL Boards and others...  When replacing board relays...

This tool can be used to drill out the hole in the boards when changing out relays.. After you desolder a relay you can use these bits to open the holes up then slide the new relay in the holes and solder.. This also helps you to prevent damage to the...

This kit is a Set of (2) Standard Balboa Board Replacement Repair Relays along with (3) Spade to Spade Jumpers used to do a beef up Jumper Style repair on Some Balboa BP Boards and others...  When replacing board relays you may need this drill bit...

This part is an optional add on to any ModPack to make the system operate a fiber optic system.. You need to let us know if your fiber box is 115v or 230v when you purchase this.. Note: This is to be purchased when you purchase a ModPack that can be...

  This part is a 3 Terminal Power Block found on some Jacuzzi or Sundance Control pack and board set ups..   Jacuzzi® Spa Terminal Block, Two Position Strip (TB1, All Models Except The J-380/J-385, J310/J-315 And J-230). Also...

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Used New Style 3 Lug Terminal Block found on many Balboa Brand Spa Hot Tub Boards. This terminal Block can get burned on one or two legs and if the soldered on finger terminals are good on the board you can replace this part and not buy a...

This Item is a Board Fuse .05Amp Slo Blo MDA Style Ceramic Fuse that measures 1 1/8" Long x 1/4" Wide and is used on some Hot Tub or Pool Boards. This is a smaller automotive style fuse that does not have glass but used ceramic to dissipate heat. You...