Electronic Control Systems and Parts

This part is a Balboa Heater M7 Sensor with a 82" wire found in some HydroQuip Systems using Balboa Boards.  Sensor Application    Spa ControlSensor Type    Hi Limit, Temp or Hi Limit,...

This part is a Balboa Heater M7 Sensor with a 46" wire found in some HydroQuip Systems using Balboa Boards.  Sensor Application    Spa ControlSensor Type    Hi Limit, Temp or Hi Limit,...

This kit is a (1) Standard Balboa Board Replacement Repair Relay along with (1) Spade to Spade Jumper and (1) Spead to Loop Jumper used to do a beef up Jumper Style repair on Some Balboa VS and EL Boards and others...  When replacing board relays...

This tool can be used to drill out the hole in the boards when changing out relays.. After you desolder a relay you can use these bits to open the holes up then slide the new relay in the holes and solder.. This also helps you to prevent damage to the...

This kit is a Set of (2) Standard Balboa Board Replacement Repair Relays along with (3) Spade to Spade Jumpers used to do a beef up Jumper Style repair on Some Balboa BP Boards and others...  When replacing board relays you may need this drill bit...

This kit is features a 1 Amp Pressure Switch and (2) Blue Spade connectors that can be used in place of the Tradional Square Pressure Switch found on some Hotspring Tubs by Watkins.. This Switch features 1/8th" MPT Standard Threads and 2 Spade...

This part is a Ground Bar found on many Balboa Brand Spa Hot Tub packs as well as some Gecko SSpa and Mspa packs.

This part is a Heater M7 Sensor with a 31" wire found in Jacuzzi Premium J series 2016 to current.  Note: This sensor does not have the nut and washer on it so it will only work with Jacuzzi Premium hot tubs..   Application Balboa...

Waterway NEO 2100 ETS Hi-Limit Sensor. These sometimes have 773-0377 on the part..   Spa Control Sensor Type Hi Limit Application Waterway Model ETS Connector Type 2 pin Wire Count 2 wire

Waterway NEO 2100 ETS (Electronic Thermal Sensing) Temperature Sensor. Similar to Balboa's M7™ Technology, the NEO 2100 uses (2) ETS sensors to determine the water temperature.     Sensor Application Spa Control Sensor...

This part is an optional add on to any ModPack to make the system operate a fiber optic system.. You need to let us know if your fiber box is 115v or 230v when you purchase this.. Note: This is to be purchased when you purchase a ModPack that can be...

This part is a GRAY Balboa Temperature Sensor Mount that accommodates 3/8” temperature sensors from Balboa, Gecko, Hydro Quip, and others. 1” hole size required. Thermowell Type Thru-Wall Sensing Bulb Size 3/8" Thru-Wall...